Semireduction of Alkynes Using Formic Acid with Reusable Pd-Catalysts

The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.

Alkynes undergo oxidative cleavage in the presence of oxidizing reagents like potassium permanganate and ozone. The triple bond — one σ bond and two π bonds — is completely cleaved, and the alkyne is oxidized to carboxylic acids. When warm and basic aqueous potassium permanganate is used as an oxidizing agent, alkynes are first converted to carboxylate salts via an unstable α-diketone intermediate. Further, a mild acid treatment protonates the carboxylate anions...

Introduction
Analogous to alkenes, alkynes also undergo acid-catalyzed hydration. While the addition of water to an alkene gives an alcohol, hydration of alkynes produces different products such as aldehydes and ketones.

Alkynes are unsaturated hydrocarbons characterized by the presence of carbon-carbon triple bonds and have a general formula CnH2n-2. The nomenclature of alkynes follows a set of rules similar to alkanes and alkenes; however, alkynes bear the suffix "-yne" instead of "-ane" or "-ene." There are two approaches to naming alkynes:

In automotive engineering, car suspension systems often employ Proportional Derivative (PD) controllers to enhance performance. PD controllers are utilized to adjust the damping force in response to road conditions. A controller, acting as an amplifier with a constant gain, demonstrates proportional control, with output directly mirroring input.
Designing a continuous-data controller requires selecting and linking components like adders and integrators, which are fundamental in Proportional,...

Proportional-Derivative (PD) control is a widely used control method in various engineering systems to enhance stability and performance. In a system with only proportional control, common issues include high maximum overshoot and oscillation, observed in both the error signal and its rate of change. This behavior can be divided into three distinct phases: initial overshoot, subsequent undershoot, and gradual stabilization.
Consider the example of control of motor torque. Initially, a positive...