Transcriptomic and cortisol analysis reveals differences in stress alleviation by different methods of anesthesia in

Qijun Le1, Jiabao Hu2, Xiaohuan Cao2

  • 1Key Laboratory of Applied Marine Biotechnology, Ningbo University, Ministry of Education, Ningbo, China; Marine Biotechnology Laboratory, Ningbo University, Ningbo, China; School of Marine Sciences, Ningbo University, Ningbo, China; Ningbo Entry-Exit Inspection and Quarantine Bureau Technical Center, Ningbo, China.

Related Concept Videos

General Anesthesia: Overview01:24

General Anesthesia: Overview

Anesthesia is a medical procedure that uses drugs for CNS suppression to enable painless surgeries and procedures. The selection of anesthetics is influenced by their pharmacokinetic properties, side effects, and patient characteristics. Various types of anesthesia include general, local, regional, spinal, and inhalational.
General anesthesia induces unconsciousness in the whole body, while the others target specific areas or sensations. It is administered to minimize adverse effects, maintain...
667
Stages of General Anesthesia01:22

Stages of General Anesthesia

Various sedation levels offer significant advantages in facilitating procedural interventions for patients undergoing medical or invasive surgical procedures. These levels span from anxiolysis to general anesthesia, providing a spectrum of sedative effects to cater to specific patient needs. Anxiolysis reduces anxiety and is achieved through minimal sedation, enabling patients to remain awake and responsive while feeling more at ease during the procedure. This level can benefit minor...
1.7K
Design of Transmission Shafts - Stress Analysis01:15

Design of Transmission Shafts - Stress Analysis

Designing a transmission shaft requires a thorough understanding of the stresses induced by bending moments and torques, especially in systems where power is transferred through gears. These forces create force-couple systems at the centers of the shaft's cross-sections, leading to both transverse and torsional loading. Although shearing stresses from transverse loads are typically smaller than those from torques and are often overlooked, the significant normal stresses from these loads...
744
Electric Potential and Potential Difference01:16

Electric Potential and Potential Difference

Suppose a positive test charge moves away from a positive static charge, then the Coulomb force does positive work, and its electric potential energy decreases. The potential energy per unit charge is defined as the electric potential. The electric potential is independent of the test charge.
When a test charge moves from the initial to the final position, the electric potential difference between those positions is defined as the ratio of the change in the potential energy to the charge on the...
5.7K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.3K
Identifying Statistically Significant Differences: The F-Test01:14

Identifying Statistically Significant Differences: The F-Test

The F-test is used to compare two sample variances to each other or compare the sample variance to the population variance. It is used to decide whether an indeterminate error can explain the difference in their values. The underlying assumptions that allow the use of the F-test include the data set or sets are normally distributed, and the data sets are independent of each other. The test statistic F is calculated by dividing one variance by another. In other words, the square of one standard...
3.8K