Depth of cure of bulk fill resin composites: A systematic review

To evaluate scientific evidence regarding depth of cure of bulk-fill resin composites (BFRCs) and related factors.

PubMed/Medline, Embase, Scopus, and ISI Web of Science databases were accessed from October 2016 to May 2017. Investigations published in English language, assessing depth of cure of BFRCs by microhardness test and/or degree of conversion (DC) were included. Studies using exclusively ISO 4049, employing specimens deepness less than 4 mm, as well as those not reporting exposure time and/or irradiance from light curing units (LCUs) were excluded.

In total, 742 studies were found from which 33 were included. From 21 studies evaluating BFRCs microhardness, 10 showed acceptable bottom/top ratios (≥0.8) for all tested materials. However, material-dependent results and non-satisfactory bottom/top microhardness ratios (<0.8) were reported in 9 and 2 investigations, respectively. From 19 studies that assessed DC, 11 showed acceptable results (≥50%) for all tested BFRCs, while 8 studies reported material-dependent outcomes. Overall, irradiance from LCUs ranged from 650 to 1330 mW/cm² and exposure time from 5 to 60 seconds. Favorable depth of cure results were observed with the use of LCUs emitting irradiance ≥1000 mW/cm² and exposure times ≥20 seconds.

High depth of cure rates by BFRCs, depends on some factors as material, irradiance and exposure time. Polywave LCUs were useful but not essential on polymerizing alternative photoinitiator-containing BFRC.

LED curing devices (polywave or monowave) displaying an irradiance ≥1000 mW/cm² and 20 seconds of exposure time are imperative to accomplish successful polymerization of most BFRCs.