Related Experiment Video
Updated: Feb 3, 2026

Microalgae Cultivation and Biomass Quantification in a Bench-Scale Photobioreactor with Corrosive Flue Gases
Published on: December 19, 2019
Enhanced biomass and lipid accumulation of mixotrophic microalgae by using low-strength ultrasonic stimulation
Hong-Yu Ren1, Ruo-Nan Xiao1, Fanying Kong1
1State Key Laboratory of Urban Water Resource and Environment, School of Environment, Harbin Institute of Technology, Harbin 150090, China.
Abstract:
Ultrasonic treatment was applied to enhance the biomass and lipid accumulation of mixotrophic microalgae. The optimal microalgal ultrasonic power, ultrasonic frequency, ultrasonic interval and growth phase were 20 W, 20 Hz, 2 s and logarithmic phase, respectively. The maximum biomass concentration and lipid content reached 2.78 g L-1 and 28.5%, which were 26.9% and 37% higher than those of the control group. Microscope analysis shows that ultrasonic exposure caused tiny cracks or holes on the surface of cell walls, but did not damage the integrity of algal cell structure. After ultrasonic stimulation, the permeability of membrane and the transport of nutrients were improved, and the utilization rate of substrate and pigment concentration increased 22.7% and 18.4%, respectively. However, excessive ultrasonic irradiation significantly inhibited the cell growth and lipid accumulation of microalgae. This study indicates the feasibility and efficiency of using low-strength ultrasound in promoting biomass and lipid production of microalgae.
Related Concept Videos
Acid Strength and Molecular Structure
In the absence of any leveling effect, the acid strength of binary compounds of hydrogen with nonmetals (A) increases as the H-A bond strength decreases down a group in the periodic table. For group 17, the order of increasing acidity is HF < HCl < HBr < HI. Likewise, for group 16, the order of increasing acid strength is H2O < H2S < H2Se < H2Te. Across a row in the periodic table, the acid strength of binary hydrogen compounds increases with increasing...
What are Lipids?
Lipid Digestion
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Relation Between Tensile Strength and Compressive Strength of Concrete
Structure of Lipids

