Related Experiment Video
Updated: Feb 3, 2026

Individualized Stem-positioning in Calcar-guided Short-stem Total Hip Arthroplasty
Published on: February 27, 2018
Unexpected dislocation following accurate total hip arthroplasty caused by excessive hip joint laxity during
Yoshiki Murotani1, Yutaka Kuroda2, Koji Goto1
1Department of Orthopaedic Surgery, Graduate School of Medicine, Kyoto University, Shogoin, Kawahara-cho 54, Sakyo-ku, Kyoto, 606-8507, Japan.
Background:
Dislocation following total hip arthroplasty is mainly caused by malposition. However, the coexistence of neuromuscular disorders is also considered a risk for dislocation due to excessive hip joint laxity. To minimize risk of dislocation, preoperative planning using combined anteversion has been widely used. The recommended combined anteversion angle (the total of cup and stem anteversion angles) is 50 ± 10°.
Case Presentation:
A 33-year-old Japanese woman underwent elective total hip arthroplasty due to osteonecrosis of the femoral head associated with corticosteroid pulse therapy for myasthenia gravis. Intraoperatively, no tendency of dislocation was found when simulating an evoking position under general anesthesia. In postoperative X-ray and computed tomography scans, cup inclination, cup anteversion, and stem anteversion angles were 37°, 13°, and 35° respectively. The resulting combined anteversion was 48°, which was set as the target along with accurate placement. Her postoperative course was normal and she was discharged without adverse events. Three months postoperatively, due to worsening of myasthenic weakness in her lower extremities while resting, she tended to raise her left limb up using both hands for sitting up. An anterior dislocation occurred when her legs were in a figure-of-four position. She was brought to an emergency department, and reduction of dislocation was performed. It was inferred that myasthenic crisis in the affected limb enabled excessive passive motion due to joint hyperlaxity. At the end of 2016, elective total hip arthroplasty on the contralateral side was performed. Cup anteversion, stem anteversion, and the combined anteversion angles were 27°, 24°, and 51° respectively. We instructed her to exercise care during passive leg movement, which may worsen her myasthenic condition. She returned to a normal life and was able to walk long distances without a cane. No recurrence of dislocation was seen at final follow-up.
Conclusions:
Even if accurate component orientation is attained in total hip arthroplasty, patients with neuromuscular disorders such as myasthenia gravis have a potential risk of muscle weakness in the affected limb. Therefore, physicians' instructions and patients' careful attention are required to prevent dislocation due to excessive hip joint laxity under conditions of motor weakness.
Related Concept Videos
Structural Joints: Synovial Joints
Excess Pressure Inside a Drop and a Bubble
Data Reporting and Recording
Structural Joints: Fibrous Joints
Suture
All the bones of the skull, except for the mandible, are joined to each other by a fibrous joint called a suture. The fibrous connective tissue found at a suture strongly unites the adjacent skull bones and thus helps to protect the brain and form the face. In...
Structural Joints: Cartilaginous Joints
There are two types of cartilaginous joints:
Synchondrosis
A synchondrosis ("joined by cartilage") is a cartilaginous joint where bones are connected by hyaline cartilage. Synchondrosis may be temporary...
Joints
Structural joint classifications are based on the material that makes up the joint as well as whether or not the joint contains a space between the bones. Joints are structurally classified as fibrous, cartilaginous, or synovial.
Fibrous Joints Are Immovable
The bones of a...

