Health information management practices in informal caregiving: An artifacts analysis and implications for IT design

Richard J Holden1, Yamini L P Karanam2, Luiz Henrique Cavalcanti2

  • 1Indiana University Center for Aging Research, Regenstrief Institute Inc., Indianapolis, IN, USA; Department of Medicine, Division of General Internal Medicine and Geriatrics, Indiana University School of Medicine, Indianapolis, IN, USA.

Abstract

Related Concept Videos

Design Example: Managing Concrete Workability01:14

Design Example: Managing Concrete Workability

This example deals with managing the workability of concrete for a raft foundation project under hot weather conditions. Workability is crucial for ensuring the concrete is easy to place, compact, and finish. In this scenario, a slump test — a common method to measure the workability of fresh concrete — initially indicated low workability. This was attributed to the rapid water loss from the concrete mix, exacerbated by the high temperatures causing the course aggregates to heat up.
313
Design of Transmission Shafts - Stress Analysis01:15

Design of Transmission Shafts - Stress Analysis

Designing a transmission shaft requires a thorough understanding of the stresses induced by bending moments and torques, especially in systems where power is transferred through gears. These forces create force-couple systems at the centers of the shaft's cross-sections, leading to both transverse and torsional loading. Although shearing stresses from transverse loads are typically smaller than those from torques and are often overlooked, the significant normal stresses from these loads...
744
Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...
10.5K
Nursing Process for Patient and Caregiver Teaching II: Planning and Implementation01:24

Nursing Process for Patient and Caregiver Teaching II: Planning and Implementation

Planning for learning involves the development of a teaching plan. Teaching plans are similar to nursing care plans—both follow the steps of the nursing process. Planning in the teaching process involves setting goals and outcomes. Here, goals identify what a patient needs to achieve to understand a healthcare topic better, whereas the outcomes are the action to be performed by the patient to achieve the goal within a timeframe. For example, if the goal is to educate the patient about...
2.1K
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
13.8K
Health Literacy01:21

Health Literacy

Health literacy is an individual's or a community's capacity to comprehend, receive, read, and use relevant healthcare information and services. The World Health Organization (WHO, 2018) defines health literacy as the cognitive and social skills that determine the ability of individuals to gain access to, understand, and use information in ways that promote and maintain good health. As a result, the WHO helps individuals manage long-term health concerns, participate in preventative...
5.4K