An Exploratory Study Using Semi-Tabular Plate in Zone II Flexor Tendon Repair

This study evaluated the feasibility of using a low-profile titanium (Ti) plate implant, also known as the Ti-button, for Zone II flexor tendon repair. We hypothesize that the use of the Ti-button can distribute the tensile force on the digital flexor tendons to achieve better biomechanical performance.

Twenty lacerated porcine flexor tendons were randomly divided into two groups and repaired using Ti-button or 6-strand modified Lim-Tsai technique. Ultimate tensile strength, load to 2 mm gap force, and mode of failure were recorded during a single cycle loading test. We also harvested twelve fingers with lacerated flexor digitorum profundus tendons from six fresh-frozen cadaver hands and repaired the tendons using either Ti-button method or modified Lim-Tsai technique. A custom-made bio-friction measurement jig was used to measure the gliding resistance and coefficient of friction of the tendon sheath interface at the A2 pulley.

The ultimate tensile strength, load to 2 mm gap force, stiffness, and gliding resistance of the Ti-button repairs were 101.5 N, 25.7 N, 7.8 N/mm, and 2.2 N respectively. Ti-button repairs had significantly higher ultimate tensile strength and stiffness than the modified Lim-Tsai repair. However, Ti-button also increased the gliding resistance and coefficient of friction but there was no significant difference between the two repair techniques.

Ti-button repair displayed comparable mechanical properties to the traditional repair in terms of 2-mm gap formation and gliding resistance, but with a stronger repair construct. Thus, this deepened our interest to further investigate the potential of using Ti-button implant in Zone II flexor tendon repair by studying both the mechanical and biochemical (tendon healing) properties in more in-depth.