Real-time mapping of heat generation and distribution in a laser irradiated agar phantom loaded with gold
Ali Farashahi1, Arash Zare-Sadeghi2, Ali Shakeri-Zadeh3
1Radiology Department, School of Allied Medical Sciences, Students Research Committee, Shahid Beheshti University of Medical Science, Tehran, Iran.
Abstract:
Gold nanoparticles (AuNPs) have shown potential strength in photothermal therapy of cancer. Several techniques have been developed to investigate local heat generation by AuNPs. However, a sensitive thermal imaging technology with high temporal resolution, minimum invasiveness and high spatial resolution is still lacking. In this research study, by using magnetic resonance thermal imaging (MRTI), we reported a technique for monitoring of heat generation and distribution in an AuNPs loaded agar phantom irradiated by laser. Three different agar phantoms with various AuNPs concentrations (0, 8 and 16 μg/ml) were produced and studied. The phantoms were exposed to an external laser [532 nm; 4 min] under MRTI. For real-time temperature monitoring, we employed the theory of proton resonance frequency (PRF) shift. Infrared (IR) camera was employed to measure the actual temperature of each point on the surface of irradiated agar gel. Finally, the correlation between the temperatures obtained by IR camera and MRTI was evaluated. We observed that temperature of the gels loaded by AuNPs at concentration of 0, 8 and 16 μg/ml reached 27.2, 37.8, 45 °C with a total area of heat distribution of 94.98, 452.16, and 907.34 mm2 (from the point of irradiation). During the process of laser irradiation, we observed: (i) a significant rise in temperature, (ii) a dependency between the rate of temperature rise and concentration of AuNPs, and (iii) a direct correlation between temperature change and MR image phase. In addition, statistical analysis showed that the variation of temperatures measured by IR camera and temperatures computed by MRTI had acceptable correlation (R > 0.9). In conclusion, MRTI has a good sensitivity and precision that can be employed for nano-photothermal therapy planning and may be considered for real-time mapping of heat generation and distribution in a laser irradiated tissue loaded by AuNPs.
Related Concept Videos
Distributed Loads
For example, consider a bookshelf filled with books stacked vertically adjacent to each other. The weight of the books is evenly distributed over the length of the shelf. As a result, the pressure at different locations on the surface of the...
Distributed Loads: Problem Solving
Resultant of a General Distributed Loading
Examples such as load distribution due to wind and load distribution on a bridge illustrate how this concept is used to analyze and design safe, reliable structures under variable loading conditions. Most structures, such as residential buildings, bridges, and towers, are...
Cable Subjected to a Distributed Load
Relation Between the Distributed Load and Shear
Elastic Curve from the Load Distribution
For all beams, the analysis of the beam's reaction to distributed loads begins by understanding the relationship between a beam's load and the resulting shear forces and bending moments. Initially, this...


