Milk intake and mammographic density in premenopausal women

Yunan Han1,2, Xiaoyu Zong1, Yize Li1

  • 1Division of Public Health Sciences, Department of Surgery, Washington University School of Medicine, Campus Box 8100, 660 South Euclid Ave, St. Louis, 63110, MO, USA.

Abstract

Related Concept Videos

Regulation of Water Intake01:25

Regulation of Water Intake

Osmolality refers to the number of solute particles per kilogram of solvent in a solution. Plasma osmolality specifically indicates the total number of solute particles per kilogram of water in blood plasma. This value reflects the body's hydration status and is tightly regulated through mechanisms controlling water intake and output. While water consumption is a conscious decision, the body has intrinsic regulatory systems to maintain fluid balance. Dehydration, a state of water deficit...
2.8K
Regulation of Food Intake01:30

Regulation of Food Intake

Short-term regulation of food intake primarily involves neural signals from the gastrointestinal (GI) tract, blood nutrient levels, and GI tract hormones. Communication between the gut and brain via vagal nerve fibers plays a significant role in evaluating the contents of the gut. Clinical studies have shown that protein ingestion produces a more prolonged response in these nerve fibers compared to an equivalent amount of glucose. Additionally, the activation of stretch receptors caused by GI...
2.9K
Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
19.9K
Current Density01:21

Current Density

The total amount of current flowing through one unit value of a cross-sectional area is referred to as current density. If the current flow is uniform, the amount of current flowing through a conductor is the same at all points along the conductor, even if the conductor area varies. The current density consists of the local magnitude and direction of the charge flow, which varies from point to point. Current density is measured in amperes per meter square, and direction is defined as the net...
5.1K
Strain-Energy Density01:20

Strain-Energy Density

Understanding the strain energy density in materials under axial load is crucial for evaluating their mechanical behavior and durability. When a rod is subjected to such a load, it elongates and stores energy, known as strain energy, as potential energy within the material. This energy is measured in terms of energy per unit volume.
In the elastic region of a material, the relationship between the stress and the strain is linear and follows Hooke's Law. The strain energy density in this region...
914
Bulk Density of Aggregate01:22

Bulk Density of Aggregate

Bulk density refers to the mass of aggregate particles that would fill a unit volume. The concept of bulk density originates from the inability to pack aggregate particles in a manner that completely eliminates void spaces. Hence, the term bulk refers to the volume that encompasses both the aggregates and the voids. This measurement is crucial when aggregates are batched by volume and is used to convert quantities by mass to volume.
Most natural mineral aggregates, like sand and gravel,...
1.2K