Biomechanics and wear comparison between mechanical and kinematic alignments in total knee arthroplasty

The uses of mechanical and kinematic alignments in total knee arthroplasty are under debate in recent clinical investigations. In this study, the differences in short-term biomechanics and long-term wear volume between mechanical and kinematic alignments in total knee arthroplasty were investigated, based on a subject-specific musculoskeletal multi-body dynamics model during walking gait simulation. An increase of 8.2% in the peak tibiofemoral medial contact force, a posterior contact translation by maximum 4.7 mm and a decrease of 5.5% in the wear volume after a 10-million-cycle simulation were predicted in the kinematic alignment, compared with the mechanical alignment. Nevertheless, the tibiofemoral contact mechanics, the range of motions and the long-term wear were not markedly different between mechanical and kinematic alignments. Furthermore, the mechanical alignment with a posterior tibial slope similar to that under the kinematic alignment was found to produce similar anterior-posterior translation and the range of motion, and an approximate wear volume, compared with the kinematic alignment. The ligament forces under the kinematic alignment were influenced markedly by as much as 25%, 50% and 77% for the medial collateral ligament, lateral collateral ligament and posterior cruciate ligament forces, respectively. And, a maximum increase of 40% for patellofemoral contact force was predicted under the kinematic alignment. These findings suggest that the kinematic alignment is an alternative alignment principle but no marked advantages in biomechanics and wear to the mechanical alignment. The adverse effects of the kinematic alignment on patella loading and soft tissue forces should be noticed.