Poor glycemic control is a strong predictor of postoperative morbidity and mortality in patients undergoing vascular

Chandler A Long1, Zachary B Fang2, Frances Y Hu3

  • 1Division of Vascular and Endovascular Surgery, Department of Surgery, Duke University School of Medicine, Durham, NC.

Journal of Vascular Surgery
|November 22, 2018
PubMed

Insights

Poor perioperative glucose control in vascular surgery patients is linked to higher 30-day mortality and increased complications. Optimizing blood sugar levels may improve outcomes for these high-risk individuals.

Area of Science:

  • Vascular Surgery
  • Endocrinology
  • Perioperative Medicine

Background:

  • Hyperglycemia is common in cardiovascular surgery patients.
  • Improved perioperative glycemic control is associated with reduced morbidity and mortality.
  • Limited data exists on glycemic control's impact in vascular surgery.

Purpose of the Study:

  • To investigate the relationship between perioperative glycemic control and postoperative outcomes in vascular surgery.
  • To identify negative perioperative outcomes potentially mitigated by improved glycemic control.

Main Methods:

  • Retrospective review of 1051 vascular surgery patients (2009-2013).
  • Included carotid endarterectomy/stenting, aortic aneurysm repair, and bypass revascularization.
  • Perioperative hyperglycemia defined as glucose >180 mg/dL within 72 hours; primary outcome was 30-day mortality.

Main Results:

  • 34.8% of patients had perioperative hyperglycemia.
  • Hyperglycemic patients showed higher 30-day mortality (5.7% vs 0.7%), acute renal failure (4.9% vs 0.9%), stroke (3.0% vs 0.7%), and infections (5.7% vs 2.6%).
  • Hyperglycemia strongly associated with increased mortality, MI, stroke, renal failure, and wound complications.

Conclusions:

  • Perioperative hyperglycemia is strongly associated with increased 30-day mortality after vascular surgery.
  • Poor glucose control correlates with multiple adverse postoperative outcomes.
  • Emphasizes the importance of glycemic management in vascular surgery patients.
Abstract

Related Concept Videos

Titration Calculations: Strong Acid - Strong Base02:28

Titration Calculations: Strong Acid - Strong Base

Calculating pH for Titration Solutions: Strong Acid/Strong Base
A titration is carried out for 25.00 mL of 0.100 M HCl (strong acid) with 0.100 M of a strong base NaOH. The pH at different volumes of added base solution can be calculated as follows:
(a) Titrant volume = 0 mL. The solution pH is due to the acid ionization of HCl. Because this is a strong acid, the ionization is complete and the hydronium ion molarity is 0.100 M. The pH of the solution is then:
33.9K
Strong Acid and Base Solutions03:22

Strong Acid and Base Solutions

A strong acid is a compound that dissociates completely in an aqueous solution and produces a concentration of hydronium ions equal to the initial concentration of acid. For example, 0.20 M hydrobromic acid will dissociate completely in water and produces 0.20 M of hydronium ions and 0.20 M of bromide ions.
35.7K
Titration of a Strong Acid with a Strong Base01:23

Titration of a Strong Acid with a Strong Base

During the titration of a strong acid with a strong base, pH calculations are primarily based on the concentration of residual hydronium or hydroxide ions. Initially, a strong acid like hydrochloric acid fully dissociates, creating hydronium and chloride ions, resulting in a low pH. The addition of a strong base like sodium hydroxide alters the concentration of hydronium ions by neutralizing them. As more base is added, the pH gradually increases. At the equivalence point, all hydronium ions...
10.5K
Seedless Vascular Plants03:24

Seedless Vascular Plants

Seedless Vascular Plants Were the First Tall Plants on Earth
66.9K
Titration Calculations: Weak Acid - Strong Base03:55

Titration Calculations: Weak Acid - Strong Base

Calculating pH for Titration Solutions: Weak Acid/Strong Base
For the titration of 25.00 mL of 0.100 M CH3CO2H with 0.100 M NaOH, the reaction can be represented as:
49.3K
Titration of a Weak Base with a Strong Acid01:20

Titration of a Weak Base with a Strong Acid

The titration curve of a weak base like ammonia with a strong acid like hydrochloric acid is the mirror image of the titration curve of a weak acid with a strong base.
Using the ICE table and substituting the Kb value, we calculate the initial pH of 50 mL of 0.1 M ammonia to be 11.11. Addition of 25 mL of 0.1 M hydrochloric acid to this solution of ammonia results in a buffer with an equal concentration of ammonia and ammonium ions. The pH of this buffer can be calculated by substituting these...
9.0K