Related Experiment Video

Updated: Feb 2, 2026

Design and Fabrication of an Optical Fiber Made of Water
08:06

Design and Fabrication of an Optical Fiber Made of Water

Published on: November 8, 2018

8.6K

Joint digital-optical design of complex lenses using a surrogate image quality criterion adapted to commercial

Marie-Anne Burcklen, Hervé Sauer, Frédéric Diaz

    Applied Optics
    |November 22, 2018
    PubMed

    More Related Videos

    Three-dimensional Optical-resolution Photoacoustic Microscopy08:31

    Three-dimensional Optical-resolution Photoacoustic Microscopy

    Published on: May 3, 2011

    18.9K
    High-resolution Fiber-optic Microendoscopy for in situ Cellular Imaging13:49

    High-resolution Fiber-optic Microendoscopy for in situ Cellular Imaging

    Published on: January 11, 2011

    35.1K

    Related Concept Videos

    Design Example: Joints in Concrete Pavements01:28

    Design Example: Joints in Concrete Pavements

    Concrete pavement joints are essential for maintaining the structural integrity and longevity of pavement by controlling where and how the pavement cracks. These joints can be categorized based on their functions, such as contraction or control joints, construction joints, isolation joints, and expansion joints.
    Contraction joints are typically formed by sawing a groove into the concrete shortly after it has hardened. This creates a weakened vertical plane, deliberately encouraging cracking at...
    514
    Group Design02:01

    Group Design

    The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...
    10.5K
    Factorial Design02:01

    Factorial Design

    Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
    13.8K
    Design Example: Designing a Residential Plumbing System01:25

    Design Example: Designing a Residential Plumbing System

    The design of residential plumbing systems requires carefully evaluating water demand, flow rates, and pressure dynamics to ensure both efficiency and reliability. The nature of water flow within pipes is defined by its Reynolds number, which classifies flow as either laminar (smooth) or turbulent.
    1.1K
    Design Example: Designing Water Slide01:18

    Design Example: Designing Water Slide

    When designing a water slide, controlling the speed of water flow is crucial for rider safety while maintaining an exciting experience. As water flows down the slide, gravity causes it to accelerate, with its speed at the bottom depending on the height from which it starts. The higher the slide, the more potential energy the water has at the top, which is converted into kinetic energy as it descends, increasing its speed.
    Bernoulli's principle determines the water's velocity along the slide....
    626
    Design Example: Design of an Irrigation Channel01:27

    Design Example: Design of an Irrigation Channel

    Trapezoidal channels are widely used in irrigation systems due to their cost-effectiveness and efficiency in conveying water. Trapezoidal channels feature a flat bottom and sloping sides, making them stable and easier to construct compared to other shapes. The bottom width and side slope ratio are determined based on the required flow capacity and site conditions. The side slope is kept gentle for unlined channels to prevent soil erosion.Hydraulic parameters in channel design include the flow...
    834