Related Experiment Video
Updated: Feb 2, 2026

The Role of Fabric in Frictional Properties of Phyllosilicate-Rich Tectonic Faults
Published on: November 6, 2021
Normal faulting and viscous buckling in the Tibetan Plateau induced by a weak lower crust
Sarah H Bischoff1, Lucy M Flesch2
1Department of Earth, Atmospheric & Planetary Sciences, Purdue University, West Lafayette, IN, 47907, USA.
Abstract:
Flow of weak lower crust has been invoked to reconcile observed topographic gradients, uniform elevations, slow seismic velocity, and high conductivity measured in the Tibetan Plateau, with viscosity estimates of 1016-1021 Pa·s. Here we investigate the dynamic response resulting from a range of lower crust viscosities in a 3-D lithospheric-scale geodynamic simulation of the India-Eurasia collision zone to determine bounds of physically viable lower crustal strengths. We show that thickening of the plateau is accommodated through viscous buckling of the upper crust in response to lower crustal flow for a lower crustal viscosity on the order of 1020 Pa·s. This generates two east-west trending bands of surface subsidence and dilatation consistent with observed normal faulting and estimates of vertical velocity. These results suggest viscous buckling of the upper crust, induced by lower crustal flow from gravitational pressure gradients due to high topography, is responsible for the observed extension in Tibet.
More Related Videos
06:45Design and Application of a Fault Detection Method Based on Adaptive Filters and Rotational Speed Estimation for an Electro-Hydrostatic Actuator
Published on: October 28, 2022
13:59A Quantitative Measurement of Reactive Oxygen Species and Senescence-associated Secretory Phenotype in Normal Human Fibroblasts During Oncogene-induced Senescence
Published on: August 12, 2018
Related Concept Videos
Weak Base Solutions
Fault Types
For line-to-line faults occurring between phases B and C, the...
Weak Acid Solutions
Titration of a Weak Acid with a Weak Base
As a result, there is no simple...
Titration Calculations: Weak Acid - Strong Base
For the titration of 25.00 mL of 0.100 M CH3CO2H with 0.100 M NaOH, the reaction can be represented as:
Normal Stress
When a rod is under axial loading, the internal forces and corresponding stress are normal to the plane of the section, so it is termed normal stress. It's important to...