Dermal disposition of Tetrabromobisphenol A Bis(2,3-dibromopropyl) ether (TBBPA-BDBPE) using rat and human skin
Gabriel A Knudsen1, Michael F Hughes2, Linda S Birnbaum1
1NCI Laboratory of Toxicology and Toxicokinetics, 111 T W Alexander Dr., Research Triangle Park, NC, 27709 USA.
Abstract:
Tetrabromobisphenol A Bis(2,3-dibromopropyl) ether (TBBPA-BDBPE) is a high production volume brominated flame retardant (BFR) used in consumer products, resulting in ubiquitous human exposure. Although the major route of exposure for this chemical is believed to be via ingestion, dermal contact is likely via contaminated dust. Independent trials of a single dose of 100 nmol/cm2 (∼1 microCi [14C]/cm2) of [14C]-radiolabeled TBBPA-BDBPE was applied to whole rat skin (in vivo) or split-thickness human and rat skin (ex vivo) to estimate in vivo human percutaneous uptake. [14C]-radioactivity was quantified to determine dermal absorption (dose retained in dosed skin) and penetrance (dose recovered in receptor fluid [ex vivo] or tissues/excreta [in vivo]) over 24 h. In vivo absorption and penetration for rat skin was 26% and 1%, with a maximum flux of 44 ± 9 pmol/cm2/h. In ex vivo rat skin, absorption and penetration and absorption values were 23% and 0.3% (flux = 26 ± 8 pmol/cm2/h). In ex vivo human skin, 53% was absorbed and penetration was 0.2% with a maximal flux of 16 ± 12 pmol/cm2/h. Computed maximal flux for in vivo human skin was 21 ± 9 pmol/cm2/h with expected total absorption of ∼80% and a penetration of <1%. HPLC-radiometric analyses of samples showed that TBBPA-BDBPE was not metabolized in ex vivo or in vivo studies. These studies indicate that TBBPA-BDBPE is likely to be dermally bioavailable even after washing and dermal contact with this chemical should be considered an important route of exposure.
More Related Videos
09:14Isolation of Papillary and Reticular Fibroblasts from Human Skin by Fluorescence-activated Cell Sorting
Published on: May 7, 2019
06:34SCAnED - An Open-source Skin Segmentation Macro for Semi-automated Cell and Nuclei Detection in Epidermal and Dermal Skin Compartments
Published on: August 8, 2025
Related Concept Videos
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
Crown Ethers
Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent...
Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Autoxidation of Ethers to Peroxides and Hydroperoxides
Ethers to Alkyl Halides: Acidic Cleavage
