Cement Distribution Patterns in Osteoporotic Vertebral Compression Fractures with Intravertebral Cleft: Effect on
Weibo Yu1, Xiang Xiao2, Jiali Zhang1
1The First Affiliated Hospital of Guangxi University of Chinese Medicine, Nanning, Guangxi.
Objective:
To determine cement distribution patterns on therapeutic efficacy after percutaneous vertebroplasty treatment of osteoporotic vertebral compression fractures (OVCFs) with intravertebral cleft (IVC).
Methods:
Patients who were treated with percutaneous vertebroplasty for single OVCFs with IVC and met this study's inclusion criteria were retrospectively reviewed. The follow-up period was at least 2 years. Distribution patterns of cement in the IVC area were respectively specified into 2 groups: group 1: solid lump distribution pattern (n = 22); group 2: the comparatively diffused pattern (n = 90). Radiologic and clinical parameters were analyzed and compared. Then, associations of recollapse with covariates and a risk score were further analyzed and developed to predict recollapse of the augmented vertebrae.
Results:
At the immediate postoperative period, all patients benefited from significant improvement in vertebrae height and kyphotic angle correction. However, significant recollapse was observed at the 2 years postoperative follow-up for the patients in group 1. Furthermore, we found that preoperative severe kyphotic deformity (a cutoff value of 12.5°), solid lump cement distribution pattern, and larger reduction angle (a cutoff value of 8.3°) was significantly associated with increased risk for recollapse. A risk score was developed based on the number of risk factors present in each patient and the receiver operating characteristic curve of the risk score generated an area under the curve of 0.788 (95% confidence interval 0.702-0.873, P = 0.000).
Conclusions:
The comparatively diffused pattern shows better long-term radiologic and clinical outcomes for the treatment for OVCFs with IVC. A risk score can be used to predict the incidence of recollapse.
More Related Videos
Related Concept Videos
Hydration of Cement
Soundness of Cement
Portland Cement
Fineness of Cement
Direct...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...


