An improved MPPT scheme employing adaptive integral derivative sliding mode control for photovoltaic systems under
Abbes Kihal1, Fateh Krim1, Abdelbaset Laib1
1Laboratory of Power Electronics and Industrial Control (LEPCI), Electronics department, Faculty of technology, University of Sétif-1, 19000, Sétif, Algeria.
Abstract:
Maximum power point tracking (MPPT) is necessary to achieve an optimal exploitation of photovoltaic (PV) system. This paper presents a novel voltage-oriented MPPT (VO-MPPT) method, where the conventional perturb and observe (P&O) algorithm is combined with the proposed external voltage control based on an adaptive integral derivative sliding mode (AIDSM). It is designed with new sliding surface, in addition, the derivative and integral terms are chosen to eliminate the overshoot during fast changes in solar irradiation and to minimize the steady-state fluctuation. Furthermore, an adaptation mechanism is joined to adjust the controller gains under each irradiation level. The proposed MPPT is tested and compared with the most widely used MPPT methods by simulations using MATLAB/SimulinkTM and real time hardware in the loop (HIL) implementation. The results obtained with the proposed MPPT show excellent dynamic performance under fast irradiation changes.
Related Concept Videos
Control Systems
At the heart...
Control Systems: Applications
In modern vehicles, control systems manage various functions to enhance performance and safety. The steering wheel and accelerator are primary inputs in a car's control system. The...
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Open and closed-loop control systems
An open-loop control system operates without feedback from the output. It consists of two primary elements: the controller and the controlled process. The controller receives an input signal...
Transfer Function in Control Systems
To derive the transfer function, consider a general nth-order linear time-invariant...
The Z-Scheme of Electron Transport in Photosynthesis


