Sensitivity and Robustness of Spatially Dependent Thrombin Generation and Fibrin Clot Propagation

Anna D Kuprash1, Alexey M Shibeko1, Ramya Vijay2

  • 1Center for Theoretical Problems of Physicochemical Pharmacology RAS, Moscow, Russia; Department of Biophysics and Systems Biology, National Center of Pediatric Hematology, Oncology and Immunology, Moscow, Russia.

Biophysical Journal
|December 6, 2018
PubMed

Blood coagulation is a delicately regulated space- and time-dependent process that leads to the formation of fibrin clots preventing blood loss upon vascular injury. The sensitivity of the coagulation network was previously investigated without accounting for transport processes. To investigate its sensitivity to coagulation factor deficiencies in a spatial reaction-diffusion system, we combined an in vitro experimental design with a computational systems biology model. Clot formation in platelet-free plasma supplemented with phospholipids was activated with identical amounts of tissue factor (TF) either homogeneously distributed (concentration 5 pM, homogeneous model) or immobilized on the surface (surface density 100 pmole/m2, spatially heterogeneous model). Fibrin clot growth and thrombin concentration dynamic in space were observed using video microscopy in plasma of healthy donors or patients with deficiencies in factors (F) II, FV, FVII, FVIII, FIX, FX, or FXI. In the spatially heterogeneous model, near-activator thrombin generation was decreased in FV-, FVII-, and FX-deficient plasma. In the homogeneous model, clotting was not registered in these samples. The simulation and experiment data showed that the coagulation threshold depended on the TF concentration. Our data indicate that the velocity of spatial clot propagation correlates linearly with the concentration of thrombin at the clot wave front but not with the overall thrombin wave amplitude. Spatial clot growth in normal plasma at early stages was neither reaction nor diffusion limited but became diffusion limited later. In contrast, clot growth was always diffusion limited in FV-, FVII-, and FX-deficient plasma and reaction limited in FVIII-, FIX-, and FXI-deficient plasma. We conclude that robustness of the spatially heterogeneous coagulation system was achieved because of the combination of 1) a local high TF surface density that overcomes activation thresholds, 2) diffusion control being shared between different active factors, and 3) an early saturated stimulus-response dependence of fibrin clot formation by thrombin.

Related Concept Videos

Clot Retraction and Fibrinolysis01:16

Clot Retraction and Fibrinolysis

After a fibrin clot is formed, the next step is clot retraction, a vital process facilitated by platelet contractile proteins, such as actin and myosin. These proteins pull the fibrin strands closer together and condense the clot. This action reduces the size of the clot, creating a smaller, denser structure that effectively seals off the damaged vessel. Clot retraction consolidates the clot and helps with wound healing by bringing the edges of the damaged blood vessel closer together.
8.9K
Propagation of Waves01:07

Propagation of Waves

When a wave propagates from one medium to another, part of it may get reflected in the first medium, and part of it may get transmitted to the second medium. In such a case, the interface of the two mediums can be considered as a boundary that is neither fixed nor free.
Consider a scenario where a wave propagates from a string of low linear mass density to a string of high linear mass density. In such a case, the reflected wave is out of phase with respect to the incident wave, however the...
3.0K
Propagation of Action Potentials01:23

Propagation of Action Potentials

The propagation of an action potential refers to the process by which a nerve impulse, or "action potential," travels along a neuron.
Neurons (nerve cells) have a resting membrane potential, with a slightly negative charge inside compared to outside. This is maintained by ion channels, such as sodium (Na+) and potassium (K+) channels, which control the flow of ions. When a stimulus, like a touch or a signal from another neuron, triggers the neuron, sodium channels open, allowing sodium ions to...
9.4K
Temperature Dependence on Reaction Rate02:55

Temperature Dependence on Reaction Rate

The Collision Theory
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
89.0K
Frequency-dependent Selection01:21

Frequency-dependent Selection

When the fitness of a trait is influenced by how common it is (i.e., its frequency) relative to different traits within a population, this is referred to as frequency-dependent selection. Frequency-dependent selection may occur between species or within a single species. This type of selection can either be positive—with more common phenotypes having higher fitness—or negative, with rarer phenotypes conferring increased fitness.
24.0K
Propagation of Uncertainty from Systematic Error01:10

Propagation of Uncertainty from Systematic Error

The atomic mass of an element varies due to the relative ratio of its isotopes. A sample's relative proportion of oxygen isotopes influences its average atomic mass. For instance, if we were to measure the atomic mass of oxygen from a sample, the mass would be a weighted average of the isotopic masses of oxygen in that sample. Since a single sample is not likely to perfectly reflect the true atomic mass of oxygen for all the molecules of oxygen on Earth, the mass we obtain from this...
1.5K