Study of Size Effect on Microstructure and Mechanical Properties of AlSi10Mg Samples Made by Selective Laser Melting

The macroscopic mechanical performance of additive manufactured structures is essential for the design and application of multiscale microlattice structure. Performance is affected by microstructure and geometrical imperfection, which are strongly influenced by the size of the struts in selective laser melting (SLM) lattice structures. In this paper, the effect of size on microstructure, geometrical imperfection, and mechanical properties was systemically studied by conducting experimental tests. A series of AlSi10Mg rod-shaped samples with various diameters were fabricated using SLM. The uniaxial tensile test results show that with the decrease in build diameter, strength and Young's modulus of strut decreased by 30% more than the stable state. The main reasons for this degradation were investigated through microscopic observation and micro X-ray computed tomography (μ-CT). In contrast with large-sized strut, the inherent porosity (1.87%) and section geometrical deviation (3%) of ponysize strut is greater because of the effect of thermal transform and hydrogen evolution, and the grain size is 0.5 μm. The discrepancy in microstructure, geometrical imperfection, and mechanical properties induced by size effect should be considered for the design and evaluation of SLM-fabricated complex structures.