Safety and efficacy at 240 weeks of different raltegravir formulations in children with HIV-1: a phase 1/2 open

Sharon Nachman1, Carmelita Alvero2, Hedy Teppler3

  • 1Health Sciences Center, Department of Pediatrics, SUNY Stony Brook, New York, NY, USA.

The Lancet. HIV
|December 12, 2018
PubMed

Insights

Raltegravir is safe and effective for treating HIV-1 in children from 4 weeks old. Long-term use shows good results, but caution is advised for older children with prior extensive antiretroviral therapy.

Area of Science:

  • Pediatric infectious diseases
  • Antiretroviral therapy research
  • HIV-1 treatment strategies

Background:

  • Raltegravir, an integrase inhibitor, is approved for HIV-1 in adults and children.
  • Limited data exist on the long-term use of raltegravir in pediatric populations.
  • This study addresses the need for long-term safety and efficacy data in children.

Purpose of the Study:

  • To assess the long-term safety, tolerability, pharmacokinetics, and efficacy of multiple raltegravir formulations in children with HIV-1.
  • To evaluate raltegravir in children aged 4 weeks to 18 years.
  • To provide data for optimizing pediatric HIV-1 treatment regimens.

Main Methods:

  • Phase 1/2 open-label multicenter trial (IMPAACT P1066) involving 153 children (aged 4 weeks to 18 years) with HIV-1.
  • Raltegravir (adult tablets, chewable tablets, granules) was added to optimized background therapy.
  • 240-week follow-up assessed safety events and virological efficacy (HIV-1 RNA reduction >1 log10 or <400 copies/mL).

Main Results:

  • Few serious safety events were observed; only one patient discontinued due to rash.
  • Virological success at 240 weeks varied by formulation: 44.2% (adult tablets), 77.4% (chewable), and 86.7% (granules).
  • Raltegravir resistance was detected in 38% of patients with virological rebound after initial suppression.

Conclusions:

  • Raltegravir demonstrates long-term safety and efficacy in children as young as 4 weeks with HIV-1 infection.
  • Different raltegravir formulations showed varying efficacy rates.
  • Caution is recommended for older children with extensive prior antiretroviral therapy due to potential resistance.
Abstract

Related Concept Videos

Predicting Products: SN1 vs. SN202:27

Predicting Products: SN1 vs. SN2

Nucleophilic substitution reactions of alkyl halides can proceed via an SN1 or an SN2 mechanism. While in SN2 reactions, the nucleophile attacks the substrate simultaneously as the leaving group departs, in SN1 reactions, the substrate first dissociates to give the carbocation intermediate. Various factors such as the structure of the substrate, the strength of the nucleophile, and the nature of the solvent promote one mechanism over the other.
With increased substitution on the alkyl halide,...
17.3K
SN1 Reaction: Stereochemistry02:15

SN1 Reaction: Stereochemistry

This lesson provides an in-depth discussion of the stereochemical outcomes in an SN1 reaction.
In the first step of an SN1 reaction, the bond between the electrophilic carbon and the leaving group ionizes to generate the carbocation intermediate. The second step of the mechanism is the nucleophilic attack.
In the formed carbocation, the positively charged carbon is sp2 hybridized with a trigonal planar geometry. As all the three substituents lie on the same plane, a plane of symmetry for the...
10.3K
SN1 Reaction: Kinetics02:05

SN1 Reaction: Kinetics

In an SN2 reaction, the reaction rate depends on both the type of nucleophile and the substrate. A hindered tertiary alkyl halide is practically inert to the SN2 mechanism despite using a strong nucleophile.
However, Sir Christopher Ingold and Edward D. Hughes, who studied the kinetics of various nucleophilic substitution reactions, noticed that a tertiary alkyl halide does undergo a nucleophilic substitution reaction in the presence of a weak nucleophile. While studying the substitution...
9.6K
SN1 Reaction: Mechanism02:25

SN1 Reaction: Mechanism

Kinetic studies of ionization of a tertiary halide in a protic solvent suggest that only the substrate participates in the rate-determining step (slow step). The nucleophile is involved only after the slowest step. The SN1 reaction takes place in a multiple-step mechanism. 
Firstly, the haloalkane ionizes to generate a carbocation intermediate and a halide ion. This heterolytic cleavage is highly endothermic with large activation energy. The ionization of the substrate, facilitated by a...
14.3K
Acidity of 1-Alkynes02:42

Acidity of 1-Alkynes


The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.
11.2K
1&deg; Amines to Diazonium or Aryldiazonium Salts: Diazotization with NaNO2 Overview01:26

1° Amines to Diazonium or Aryldiazonium Salts: Diazotization with NaNO2 Overview

Nitrous acid and nitric acids are two types of acids containing nitrogen, among which nitrous acid is weaker than nitric acid. Nitrous acid with a pKa value of 3.37 ionizes in water to give a nitrite ion and the hydronium ion.
The nitrous acid is unstable. Hence, it is formed in situ from a solution of sodium nitrite and cold aqueous acids such as hydrochloric or sulfuric acid. In an acidic solution, the –OH group of nitrous acid undergoes protonation to give oxonium ion, followed by...
3.9K