Immersion anaesthesia in goldfish (Carassius auratus) with three concentrations of alfaxalone

Fabio Leonardi1, Giovanna Lucrezia Costa2, Claudia Dina Interlandi2

  • 1Department of Veterinary Science, University of Parma, Parma, Italy.

Abstract

Related Concept Videos

Concentration Cells02:41

Concentration Cells

A concentration cell is a type of a  voltaic cell constructed by connecting two almost identical half-cells, both based on the same half-reaction and using the same electrode, differing only in the concentration of one redox species. A concentration cell's potential, therefore, is determined only by the concentration difference of the particular redox species.
Consider the following voltaic cell:
25.9K
General Anesthesia: Overview01:24

General Anesthesia: Overview

Anesthesia is a medical procedure that uses drugs for CNS suppression to enable painless surgeries and procedures. The selection of anesthetics is influenced by their pharmacokinetic properties, side effects, and patient characteristics. Various types of anesthesia include general, local, regional, spinal, and inhalational.
General anesthesia induces unconsciousness in the whole body, while the others target specific areas or sensations. It is administered to minimize adverse effects, maintain...
665
Stages of General Anesthesia01:22

Stages of General Anesthesia

Various sedation levels offer significant advantages in facilitating procedural interventions for patients undergoing medical or invasive surgical procedures. These levels span from anxiolysis to general anesthesia, providing a spectrum of sedative effects to cater to specific patient needs. Anxiolysis reduces anxiety and is achieved through minimal sedation, enabling patients to remain awake and responsive while feeling more at ease during the procedure. This level can benefit minor...
1.7K
Solution Concentration and Dilution02:59

Solution Concentration and Dilution

The relative amount of a given solution component is known as its concentration. Often, though not always, a solution contains one component with a concentration that is significantly greater than that of all other components. This component is called the solvent and may be viewed as the medium in which the other components are dispersed or dissolved. Solutions in which water is the solvent are, of course, very common on our planet. A solution in which water is the solvent is called an aqueous...
133.8K
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
637
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
703