Related Experiment Video
Updated: Feb 1, 2026

A Colorimetric Method for Measuring Iron Content in Plants
Published on: September 7, 2018
Measuring the water content in freshly-deposited fingermarks
Or Keisar1, Yair Cohen2, Yacov Finkelstein2
1Israel Atomic Energy Commission (IAEC), Israel.
Abstract:
The literature view regarding the composition of deposited fingermarks has long been that the average water content is in the range of 98-99wt.%. This value has recently been challenged by Kent, claiming that it should be 20wt.% at most. Herein we have measured the weight percentage of water content in freshly-deposited fingermarks, with and without hand pre-washing. Two complementary techniques were utilized for the measurements, namely quartz crystal microbalance (QCM) for determining the relative mass-loss and its rate at ca. 37°C, and temperature-programmed desorption-mass spectrometry (TPD-MS) for establishing that the mass loss arises solely from the complete evaporation of all the water content in the fingermarks (done with hand pre-washing only). Unlike the traditional narrow-range values of 98-99% and the limiting value of 20wt.% suggested by Kent, our measurements indicate the occurrence of a broad 20-70% water content. Higher contents of water in fingermarks were found post hand pre-washing, most probably due to removal of the sebum from the fingertips, but none of the results exceeded 90%.
More Related Videos
08:31The Calibration and Use of Capacitance Sensors to Monitor Stem Water Content in Trees
Published on: December 27, 2017
08:09Measuring and Mapping Patterns of Soil Erosion and Deposition Related to Soil Carbonate Concentrations Under Agricultural Management
Published on: September 12, 2017
Related Concept Videos
Body Water Content and Fluid Compartments
Measurement of Air Content in Concrete
The pressure method,...
States of Water
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
Phase Transitions: Sublimation and Deposition
Stereotype Content Model
Segregation in Fresh Concrete