One can be some but some cannot be one: ERP correlates of numerosity incongruence are different for singular and

Giorgio Arcara1, Francesca Franzon2, Simone Gastaldon3

  • 1Fondazione Ospedale San Camillo IRCCS, Venezia, Italia.

Related Concept Videos

Singularity Functions for Shear01:26

Singularity Functions for Shear

In structural analysis, singularity functions are crucial in simplifying the representation of shear forces in beams under discontinuous loading. These functions describe discontinuous  variations in shear force across a beam with varying loads by using a single mathematical expression, regardless of the complexity of the loading conditions. The singularity functions are derived from creating a free-body diagram of the beam and then making conceptual cuts at specific points to examine the...
447
Correlations02:20

Correlations

Correlation means that there is a relationship between two or more variables (such as ice cream consumption and crime), but this relationship does not necessarily imply cause and effect. When two variables are correlated, it simply means that as one variable changes, so does the other. We can measure correlation by calculating a statistic known as a correlation coefficient. A correlation coefficient is a number from -1 to +1 that indicates the strength and direction of the relationship between...
35.9K
Correlation and Causation01:27

Correlation and Causation

Statistical tests can calculate whether there is a relationship, or correlation, between independent and dependent variables. An indirect relationship of the variables signifies a correlation, while a direct relationship shows causation. If it is determined that no connection exists between the variables, then the correlation is a coincidence.
Correlation versus Causation
If the dependent variable increases or decreases when the independent variable increases, there is a positive or negative...
42.6K
Singularity Functions for Bending Moment01:18

Singularity Functions for Bending Moment

Singularity functions simplify the representation of bending moments in beams subjected to discontinuous loading, allowing the use of a single mathematical expression. For a supported beam AB, with uniform loading from its midpoint M to the right side end B, the approach involves conceptual 'cuts' at specific points to determine the bending moment in each segment. By cutting the beam at a point between A and M, the bending moment for the segment before reaching midpoint M is represented using a...
556
Correlation01:09

Correlation

In statistics, two variables are said to be correlated if the values of one variable are associated with the other variable. Depending on the relationship between two variables, correlation can be of three types– positive correlation, negative correlation, and zero correlation.
Two variables, for example, a and b, are said to be positively correlated if both variables move in the same direction. In other words, a positive correlation exists between two variables, a and b, if:
15.1K
Correlation and Regression00:53

Correlation and Regression

In statistics, correlation describes the degree of association between two variables. In the subfield of linear regression, correlation is mathematically expressed by the correlation coefficient, which describes the strength and direction of the relationship between two variables. The coefficient is symbolically represented by 'r' and ranges from -1 to +1. A positive value indicates a positive correlation where the two variables move in the same direction. A negative value suggests a...
3.4K