Renewing the performance of an expired particle packed column using active flow technology end fittings

The performance of a particle packed column will inevitably degrade through use or misadventure. 'Active flow technology' (AFT) is known to greatly improve the performance of pristine columns, but is as of yet untested when used on columns that have degraded significantly. In this study AFT was used to regenerate a degraded column, where the reduced plate height and asymmetry values were 3.5 and 1.25 respectively. Once the AFT fittings were fitted to the column outlet and the flow segmentation ratio adjusted to 28% from the radial central exit port, the reduced plate height decreased to 2.0, and the bands were almost perfectly symmetrical with asymmetry factors equal to 1.04. Subsequently, the performance of the degraded column with AFT fittings provided performance that was comparable to that of a new conventional column fitted with traditional end fittings. The separation power of the degraded conventional column and that of the same column fitted with the AFT end fittings was then tested using the separation of oligostyrenes. In AFT mode, detection was undertaken at both the radial central exit port of the column and the peripheral exit port. The resulting separation that was achieved from the radial central exit port was superior to that observed on the conventional column, whereas, the separation observed from the peripheral port was very poor. It was subsequently determined that the reason for the degraded performance of the conventional column was a result of increased heterogeneity associated with the packing material in the wall region of the column.