Short-course palliative radiation therapy leads to excellent bleeding control: A single centre retrospective study

Lucas Gomes Sapienza1,2, Matthew Stephen Ning3, Anuja Jhingran3

  • 1Department of Radiation Oncology, A.C. Camargo Cancer Center, São Paulo, SP, Brazil.

Abstract

Related Concept Videos

Phase-lead and Phase-lag Controllers01:22

Phase-lead and Phase-lag Controllers

Understanding the working function of different types of controllers can be illustrated with practical analogies, such as adjusting a stereo's volume equalizer. Cranking up the bass involves a phase-lead controller, which functions as a high-pass filter, while increasing the treble uses a phase-lag controller, which acts as a low-pass filter. PD controllers, similar to high-pass filters, enhance the system's response to high-frequency components. PI controllers, akin to low-pass...
546
Time and frequency -Domain Interpretation of Phase-lead Control01:24

Time and frequency -Domain Interpretation of Phase-lead Control

Phase-lead controllers are commonly used in various control systems to enhance response speed and stability. Adjusting the brightness on a television screen offers a practical example of phase-lead control. When contrast is enhanced, a phase-lead controller is employed. Mathematically, phase-lead control is identified when the first parameter is smaller than the second.
The design of phase-lead control involves the strategic placement of poles and zeros to balance steady-state error and system...
454
Microsoft Excel: Plotting Mean, SD, and SE01:18

Microsoft Excel: Plotting Mean, SD, and SE

In Microsoft Excel, plotting the mean along with standard deviation (SD) and standard error (SE) helps visualize data variability and reliability. To plot these values, follow these steps:
First, calculate the mean, SD, and SE of your data. The mean is obtained using the formula `=AVERAGE(range)`, while SD can be calculated with `=STDEV.P(range)` for a population or `=STDEV.S(range)` for a sample. SE is calculated as `=SD/SQRT(n)`, where `n` is the sample size.
To plot these values, use a bar...
1.2K
Biological Effects of Radiation02:59

Biological Effects of Radiation

All radioactive nuclides emit high-energy particles or electromagnetic waves. When this radiation encounters living cells, it can cause heating, break chemical bonds, or ionize molecules. The most serious biological damage results when these radioactive emissions fragment or ionize molecules. For example, α and β particles emitted from nuclear decay reactions possess much higher energies than ordinary chemical bond energies. When these particles strike and penetrate matter, they...
17.9K
Physical Methods for Controlling Microbial Growth: Radiation and Filtration01:26

Physical Methods for Controlling Microbial Growth: Radiation and Filtration

Radiation and filtration are essential tools for microbial control, targeting microorganisms through distinct mechanisms. Radiation eliminates microbes by damaging their DNA, either killing them or inhibiting their growth. Based on wavelength, radiation is classified into two types: nonionizing and ionizing radiation.Non-ionizing radiation, such as UV radiation (200–400 nm), is absorbed by DNA, causing defects that effectively disinfect surfaces, air, and water, including safety cabinets.
1.1K
Microsoft Excel: Student's t-Test01:25

Microsoft Excel: Student's t-Test

Student's t-test in Microsoft Excel is a statistical method used to compare the means of two groups to determine if they are significantly different from each other. It's commonly used to evaluate hypotheses, such as testing whether a treatment has an effect compared to a control group. Excel provides built-in functions to perform t-tests, making it accessible for users needing to conduct basic statistical analysis.
To conduct a t-test in Excel, use the T.TEST function or the "Data...
1.6K