Related Experiment Video

Updated: Jan 31, 2026

Experimental Methods for Efficient Solar Hydrogen Production in Microgravity Environment
11:38

Experimental Methods for Efficient Solar Hydrogen Production in Microgravity Environment

Published on: December 3, 2019

8.1K

Photoelectrochemical Gas-Electrolyte-Solid Phase Boundary for Hydrogen Production From Water Vapor

Fumiaki Amano1,2, Ayami Shintani1, Hyosuke Mukohara1

  • 1Department of Chemical and Environmental Engineering, The University of Kitakyushu, Kitakyushu, Japan.

Frontiers in Chemistry
|December 19, 2018
PubMed

Keywords:
gas-phase water splittingproton exchange membranesolar H2 productiontungsten oxide photoanodevisible-light-driven photoelectrode

More Related Videos

Gas Chromatography-Mass Spectrometry Paired with Total Vaporization Solid-Phase Microextraction as a Forensic Tool05:31

Gas Chromatography-Mass Spectrometry Paired with Total Vaporization Solid-Phase Microextraction as a Forensic Tool

Published on: May 25, 2021

8.4K
Hydrogen Charging of Aluminum using Friction in Water07:50

Hydrogen Charging of Aluminum using Friction in Water

Published on: January 28, 2020

6.5K

Related Concept Videos

Phase Transitions: Vaporization and Condensation02:39

Phase Transitions: Vaporization and Condensation

The physical form of a substance changes on changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. Vaporization occurs when the thermal motion of the molecules overcome the intermolecular forces, and the molecules (at the surface) escape into the gaseous state. When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules...
21.3K
Vapor Pressure02:34

Vapor Pressure

When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules move randomly about, they will occasionally collide with the surface of the condensed phase, and in some cases, these collisions will result in the molecules re-entering the condensed phase. The change from the gas phase to the liquid is called condensation. When the rate of condensation becomes equal to the rate of vaporization, neither the amount of the liquid nor the amount of the vapor...
40.6K
Phase Diagrams02:39

Phase Diagrams

A phase diagram combines plots of pressure versus temperature for the liquid-gas, solid-liquid, and solid-gas phase-transition equilibria of a substance. These diagrams indicate the physical states that exist under specific conditions of pressure and temperature and also provide the pressure dependence of the phase-transition temperatures (melting points, sublimation points, boiling points). Regions or areas labeled solid, liquid, and gas represent single phases, while lines or curves represent...
50.2K
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
56.8K
Electrolyte and Nonelectrolyte Solutions02:21

Electrolyte and Nonelectrolyte Solutions

Substances that undergo either a physical or a chemical change in solution to yield ions that can conduct electricity are called electrolytes. If a substance yields ions in solution, that is, if the compound undergoes 100% dissociation, then the substance is a strong electrolyte. Complete dissociation is indicated by a single forward arrow. For example, water-soluble ionic compounds like sodium chloride dissociate into sodium cations and chloride anions in aqueous solution.
71.9K
Vaporization01:18

Vaporization

The physical form of a substance changes by changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. For vaporization to occur, kinetic energy must be greater than the intermolecular forces that keep molecules bonded. The amount of energy needed to vaporize a quantity of liquid at a given pressure and a constant temperature is called the heat of vaporization. When...
38.1K