Postdischarge outcome after Takotsubo syndrome compared with patients post-ACS and those without prior CVD: ANZACS-QI

Jen-Li Looi1, Mildred Lee1, Mark W I Webster2

  • 1Department of Cardiology, Middlemore Hospital, Auckland, New Zealand.

Open Heart
|December 20, 2018
PubMed
Abstract

Related Concept Videos

AC Sources01:20

AC Sources

Direct current is a flow of electric charge in only one direction and has a steady state of constant voltage in the circuit. Rectifiers, batteries, commutator-equipped generators, and fuel cells are some examples of devices that generate direct current. Nowadays, most applications use a time-varying voltage source. Alternating current is a flow of electric charge that periodically reverses direction. An alternating current is produced by an alternating emf that is generated in a power plant. If...
4.1K
Resistor in an AC Circuit01:31

Resistor in an AC Circuit

An alternating emf or voltage source is needed to supply an alternating current (AC) to a circuit. A coil of wire rotating in a magnetic field at a constant angular speed represents such a source. It also generates a sinusoidal alternating emf and serves as an industrial alternator.
One-way current through the meter is measured using diodes. A diode is a device with better conductivity in one direction compared to the other; in its ideal state, it has zero resistance in one direction and allows...
3.2K
Power in an AC Circuit01:26

Power in an AC Circuit

In a DC circuit, the power consumed is simply the product of the DC voltage times the DC current, given in watts. However, the power consumed for AC circuits with reactive components is calculated differently. Since electrical power is the "rate" at which energy is used in a circuit, all electrical and electronic components and devices have a safe operating range for electrical power.
In a DC circuit, there is no sinusoidal waveform associated with the supply; the voltages and currents are...
2.3K
Predicting Reaction Outcomes02:24

Predicting Reaction Outcomes

Kinetics describes the rate and path by which a reaction occurs. In contrast, thermodynamics deals with state functions and describes the properties, behavior, and components of a system. It is not concerned with the path taken by the process and cannot address the rate at which a reaction occurs. Although it does provide information about what can happen during a reaction process, it does not describe the detailed steps of what appears on an atomic or a molecular level. On the other hand,...
10.8K
Outcomes of Glycolysis01:13

Outcomes of Glycolysis

Nearly all the energy used by cells comes from the bonds that make up complex organic compounds. These organic compounds are broken down into simpler molecules, such as glucose. As a result, cells extract energy from glucose over many chemical reactions—a process called cellular respiration.
Cellular respiration can occur aerobically (with oxygen) or anaerobically (without oxygen). In the presence of oxygen, cellular respiration starts with glycolysis and continues with pyruvate...
107.2K
RMS Value in AC Circuit01:13

RMS Value in AC Circuit

The root mean square (RMS) value is a measure of the effective or average value of an alternating current (AC) waveform. In AC circuits, the voltage or current waveform constantly changes direction and magnitude, making it difficult to describe with a single value. The RMS value provides a convenient way to calculate the equivalent DC voltage or current that would produce the same heating effect in a resistor as the AC waveform.
Mathematically, the RMS value of an AC waveform is the square root...
3.4K