Related Experiment Video
Updated: Jan 31, 2026

Comparison of Kinetic Characteristics of Footwork during Stroke in Table Tennis: Cross-Step and Chasse Step
Published on: June 16, 2021
The effect characteristics of temperature on stroke mortality in Inner Mongolia and globally
Wenfang Guo1, Maolin Du2, Dejun Sun3
1Inner Mongolia Autonomous Region Academy of Chinese Medicine, Hohhot, China.
Abstract:
The current study investigated the correlation between stroke mortality and temperature. Monthly and seasonal variations in stroke mortality were plotted and daily stroke-related deaths were calculated. The lag times were calculated using the time series analysis. The correlation between stroke incidence and the diurnal temperature range (DTR) was analyzed using case-crossover analysis. Global stroke mortality was described in five latitudes. In the eastern region of Inner Mongolia, the stroke mortality was 174.18/105, about twice of that of the midwestern regions (87.07/105), and temperature was negatively correlated with stroke mortality. Mortality peaked in the winter and troughed in the summer (χ2 = 13.634, P < 0.001). The days in which stroke-related deaths were greater than ten occurred between late October and early April. The effect of temperature on stroke incidence occurred during a lag time of 1 (P = 0.024) or 2 months (P = 0.039). A DTR over 13 °C was positively correlated (r = 0.95, P = 0.004) with stroke with a lag time of 1 day. The effect of temperature on stroke was shown to be the same for various populations. As the latitude increases, stroke mortality also increases with latitudes > 40°; the highest mortality was 188.05/105 at the highest latitude. Only in relatively cold regions as the temperature decreases does stroke mortality increase for various populations. Differences in the time lag as well as in the DTR lag and DTR critical point vary for both the temperature and region.
Related Concept Videos
Global Climate Change
Characteristics of Life
Characteristics of Fluids
Characteristics of Fluids
Fluids, which include both liquids and gases, are substances that deform continuously under shearing stress. For example, water and oil are liquids with molecules that can...
Characteristics of BJT
For input characteristics, the base-emitter voltage is varied, maintaining a constant collector-emitter voltage. This setup reveals a Shockley-type dependence of the collector current on...
Characteristics of JFET
The core of a JFET's operation is controlling drain current by modulating the gate-source voltage. When the drain and gate voltage are set to zero, the JFET exhibits no net current flow, representing a state of equilibrium. The drain current increases linearly as the...

