Three-dimensional measurement of glenoid dimensions and orientations

Asians generally have smaller stature than Europeans and Americans, and currently available implants used in reverse shoulder arthroplasty might not fit smaller bony anatomies. However, few articles have reported glenoid geometry in the Asian population. The purpose of this study was to measure the dimensions and orientations of the glenoid from three-dimensional computed tomography reconstructions of elderly Japanese subjects.

This study included 100 shoulders (50 males and 50 females with >50 years of age). The mean age was 67 ± 7 years for both sexes, and the mean height was 167 ± 7 cm for males and 154 ± 6 cm for females. Three-dimensional scapular models were created from computed tomographic images, and the glenoid height, glenoid width, glenoid version, glenoid inclination, vault depth, and vault width were measured.

The mean glenoid height and width were 38.6 and 29.4 mm for males and 33.1 and 24.4 mm for females, respectively. Both retroversion and superior inclination were approximately 3° in both sexes. The glenoid vault was deeper in the posterior region with the maximum depth of 26.1 and 23.6 mm in males and females. The vault width was narrower in the anterior region with the anterior width of 2.5 mm at 15 mm medial from the glenoid face in females.

Glenoids of Japanese females are small compared to currently available baseplates for reverse shoulder arthroplasty. These results may be helpful to aid design in smaller baseplates that better fit the anatomic geometry of the Asian glenoid.