Related Experiment Video

Updated: Jan 31, 2026

Author Spotlight: Assessing the Impact of Novel Iron Chelators on Cancer Cell Metabolism
05:36

Author Spotlight: Assessing the Impact of Novel Iron Chelators on Cancer Cell Metabolism

Published on: February 23, 2024

975

Room-temperature Chelate Vapor Generation of Lead Using Ammonium O,O-Diethyl Dithiophosphate as a Chelating Reagent

Shuai Liu1, Jinsheng Sun1, Jianzhong Huo2

  • 1College of Life Sciences, Tianjin Key Laboratory of Animal and Plant Resistance, Tianjin Normal University.

Analytical Sciences : the International Journal of the Japan Society for Analytical Chemistry
|January 5, 2019
PubMed

Keywords:
Chelate vapor generationPbatomic fluorescence spectrometry

More Related Videos

Automated Gel Size Selection to Improve the Quality of Next-generation Sequencing Libraries Prepared from Environmental Water Samples13:26

Automated Gel Size Selection to Improve the Quality of Next-generation Sequencing Libraries Prepared from Environmental Water Samples

Published on: April 17, 2015

11.0K
Determination of Inorganic Arsenic in a Wide Range of Food Matrices using Hydride Generation - Atomic Absorption Spectrometry.08:21

Determination of Inorganic Arsenic in a Wide Range of Food Matrices using Hydride Generation - Atomic Absorption Spectrometry.

Published on: September 1, 2017

16.0K

Related Concept Videos

Complexation Equilibria: The Chelate Effect01:19

Complexation Equilibria: The Chelate Effect

In complexation reactions, metal atoms or cations interact with ligands to form donor-acceptor adducts called metal complexes. Ligands that bind through one donor site are monodentate, ligands with two donor sites are bidentate, and those with more than two donor sites are polydentate ligands. For example, ethylene diamine is a bidentate ligand that binds through two nitrogen donor atoms, forming a five-membered ring. EDTA is a polydentate ligand that binds through four oxygen and two nitrogen...
1.3K
Vapor Pressure02:34

Vapor Pressure

When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules move randomly about, they will occasionally collide with the surface of the condensed phase, and in some cases, these collisions will result in the molecules re-entering the condensed phase. The change from the gas phase to the liquid is called condensation. When the rate of condensation becomes equal to the rate of vaporization, neither the amount of the liquid nor the amount of the vapor...
40.6K
Vaporization01:18

Vaporization

The physical form of a substance changes by changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. For vaporization to occur, kinetic energy must be greater than the intermolecular forces that keep molecules bonded. The amount of energy needed to vaporize a quantity of liquid at a given pressure and a constant temperature is called the heat of vaporization. When...
38.0K
Atomic Mass01:52

Atomic Mass

Atoms — and the protons, neutrons, and electrons that compose them — are extremely small. For example, a carbon atom weighs less than 2 × 10−23 g. When describing the properties of tiny objects such as atoms, we use appropriately small units of measure, such as the atomic mass unit (amu). The amu was originally defined based on hydrogen, the lightest element, then later in terms of oxygen. Since 1961, it has been defined with regard to the most abundant isotope of carbon, atoms of which...
70.1K
Atomic Spectroscopy: Effects of Temperature01:27

Atomic Spectroscopy: Effects of Temperature

Atomization, converting samples into gas-phase atoms and ions, is essential for atomic spectroscopy. The flame temperature required for atomization affects the efficiency of the atomic spectroscopic methods by increasing the atomization efficiency and the relative population of the excited and ground states.
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
903
Atomic Fluorescence Spectroscopy01:29

Atomic Fluorescence Spectroscopy

Atomic fluorescence spectroscopy (AFS) is an analytical technique that involves the electronic transitions of atoms in a flame, furnace, or plasma being excited by electromagnetic (EM) radiation. When these atoms absorb energy, they become excited and subsequently release energy as they return to their original state. This emitted light, or "fluorescence," is observed at a right angle to the incident beam. Both absorption and emission processes transpire at distinct wavelengths, which...
959