Related Experiment Video
Updated: Jan 31, 2026

The Other End of the Leash: An Experimental Test to Analyze How Owners Interact with Their Pet Dogs
Published on: October 13, 2017
Effect of methadone and acepromazine premedication on tear production in dogs
Hayley A Volk1, Ellie West2, Rose Non Linn-Pearl3
1Melbourne EyeVet, Mulgrave, VIC, Australia.
Objectives:
To evaluate the combined effect of intramuscular acepromazine and methadone on tear production in dogs undergoing general anaesthesia for elective, non-ocular procedures.
Design:
Prospective, non-randomised, pre-post treatment study.
Setting:
Patients were recruited from a referral practice in the UK.
Methods:
Thirty client-owned dogs were enrolled in this study and received a combined intramuscular premedication of methadone (0.3 mg/kg) and acepromazine (0.02 mg/kg) before general anaesthesia for elective, non-ocular procedures. Full ophthalmic examination was performed and tear production was quantified using the Schirmer tear test-1 (STT-1). On the day of general anaesthesia, an STT-1 was performed before (STT-1a) and after (STT-1b) intramuscular premedication with methadone/acepromazine.
Results:
Using a general linear model, a significant effect on STT-1 results was found for premedication with methadone/acepromazine (P=0.013), but not eye laterality (P=0.527). Following premedication, there was a significant reduction observed in the mean STT-1 readings of left and right eyes between STT-1a (20.4±2.8 mm/min) and STT-1b (16.9±4.1 mm/min; P<0.001). Significantly more dogs had an STT-1 reading less than 15 mm/min in one or both eyes after premedication (30 per cent; 9/30 dogs) compared with before premedication (6.7 per cent; 2/30 dogs; P=0.042).
Conclusions:
An intramuscular premedication of methadone and acepromazine results in a decrease in tear production in dogs before elective general anaesthesia. This may contribute to the risk of ocular morbidities, such as corneal ulceration, particularly in patients with lower baseline tear production.
Related Concept Videos
Scalar Product (Dot Product)
The scalar product of two vectors is obtained by multiplying...
Vector Product (Cross Product)
Consider the cross product of two vectors. Imagine rotating the first vector about...
Primary Production
Production Efficiency
The Dot Product
Dot Product
In engineering, the dot product of any two vectors is the product of the magnitudes of the vectors and the cosine of the angle between them. It is denoted by a dot symbol between the two vectors.
Consider a vehicle pulling an object along the ground using a rope. If the rope makes an angle with the horizontal axis, the work done can be calculated using the dot product of the force applied and the object's displacement.
The dot...

