Related Experiment Video
Updated: Jan 31, 2026
Surgical Swine Model of Chronic Cardiac Ischemia Treated by Off-Pump Coronary Artery Bypass Graft Surgery
Published on: March 27, 2018
Utilization of arterial pulse waveform analysis during non-cardiac surgery in Japan: a retrospective observational
Chikashi Takeda1,2, Masato Takeuchi1, Toshiyuki Mizota2
1Department of Pharmacoepidemiology, Graduate School of Medicine and Public Health, Kyoto University, Yoshida-Konoe-cho, Sakyo-ku, Kyoto, 606-8501, Japan.
Abstract:
Arterial pulse waveform analysis (APWA) is used for cardiac output monitoring. However, data on the frequency of and patient characteristics for specialized pressure transducer for APWA (S-APWA) use are lacking. We retrospectively identified 175,201 patients aged 18 years or older, who underwent non-cardiac surgery under general anesthesia with an arterial catheter from January 1, 2014, to December 31, 2016. We extracted data on patient demographics, comorbidities, surgical and anesthesia characteristics, and hospital characteristics. Among the full study cohort, 24,605 (14.0%) patients were monitored using S-APWA. Further, the use of S-APWA was higher in patients undergoing high-risk surgery than in those undergoing low-risk surgery [high vs low: adjusted odds ratio (aOR) 1.95; 95% confidence interval (CI) 1.76-2.15, moderate vs low: aOR 1.11; 95% CI 1.01-1.22] and those with more comorbidities than in those with less comorbidities (high vs low: aOR 1.49; 95% CI 1.42-1.56, moderate vs low: aOR 1.25; 95% CI 1.20-1.31). S-APWA use was significantly associated with both surgery risk and patients' comorbidities. In conclusion, our study may provide a benchmark for future studies related to the appropriate use of S-APWA.
Related Concept Videos
01:11Observational Studies
There are three types of observational studies – Prospective, retrospective, and cross-sectional.
Prospective Study
Prospective studies, also known as longitudinal or cohort studies, are carried out by collecting future data from groups sharing similar characteristics. One...
01:11Testing a Claim about Mean: Known Population SD
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...
01:07Effective Value of a Periodic Waveform
The effective value of a periodic current represents the direct current (DC) that conveys the same average power to a resistor as the periodic current itself. This concept is crucial when assessing AC circuits. To determine the...
01:24Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
01:19Testing a Claim about Standard Deviation
The hypothesis testing for the claim of population standard deviation (or variance) requires the data and samples to be random and unbiased. The population distribution also must be normal. There is no specific requirement on the sample size as the estimation is based on the chi-square distribution.
As a first step, the hypothesis (null and alternative) concerning the claim about...
01:21Testing a Claim about Mean: Unknown Population SD
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used;...