[Effect of Aeration Density on Start-up of CANON Process]

Dong Li1, Xue-Jian Gao1, Jie Zhang1,2

  • 1Key Laboratory of Beijing for Water Quality Science and Water Environment Recovery Engineering, Beijing University of Technology, Beijing 100124, China.

Related Concept Videos

Non-Canonical Wnt Signaling Pathways01:41

Non-Canonical Wnt Signaling Pathways

Wnt is a zygotic effect gene that is expressed during very early embryonic development. It regulates various processes in animals starting from early development through the adult stage, such as organogenesis in the embryo and maintenance of neuronal and blood stem cells. Wnt proteins can induce a wide variety of intracellular pathways depending upon the specific abilities of different Wnt ligands to form a complex with shared and cognate receptors in the presence of different co-receptors. The...
8.4K
Canonical Wnt Signaling Pathway02:54

Canonical Wnt Signaling Pathway

The gene encoding the main signaling molecules of the Wnt signaling pathways (the Wnt proteins) was discovered almost four decades ago by Nüsslein-Volhard and Wieschaus. They identified and originally named the gene "wingless" (wg) after a phenotype discovered during their landmark genetic screen in Drosophila for body pattern defects. At around the same time, another researcher named Harold Varmus found that a murine tumor virus activates the mammalian wg homolog, Int-1, which...
10.6K
Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
19.9K
Current Density01:21

Current Density

The total amount of current flowing through one unit value of a cross-sectional area is referred to as current density. If the current flow is uniform, the amount of current flowing through a conductor is the same at all points along the conductor, even if the conductor area varies. The current density consists of the local magnitude and direction of the charge flow, which varies from point to point. Current density is measured in amperes per meter square, and direction is defined as the net...
5.1K
Strain-Energy Density01:20

Strain-Energy Density

Understanding the strain energy density in materials under axial load is crucial for evaluating their mechanical behavior and durability. When a rod is subjected to such a load, it elongates and stores energy, known as strain energy, as potential energy within the material. This energy is measured in terms of energy per unit volume.
In the elastic region of a material, the relationship between the stress and the strain is linear and follows Hooke's Law. The strain energy density in this region...
907
Bulk Density of Aggregate01:22

Bulk Density of Aggregate

Bulk density refers to the mass of aggregate particles that would fill a unit volume. The concept of bulk density originates from the inability to pack aggregate particles in a manner that completely eliminates void spaces. Hence, the term bulk refers to the volume that encompasses both the aggregates and the voids. This measurement is crucial when aggregates are batched by volume and is used to convert quantities by mass to volume.
Most natural mineral aggregates, like sand and gravel,...
1.2K