Related Experiment Video

Updated: Jan 31, 2026

Facile Preparation of Ultrafine Aluminum Hydroxide Particles with or without Mesoporous MCM-41 in Ambient Environments
05:50

Facile Preparation of Ultrafine Aluminum Hydroxide Particles with or without Mesoporous MCM-41 in Ambient Environments

Published on: May 11, 2017

11.3K

Aromatic amines equilibrium sorptive interaction with synthesized silica based mesoporous MCM-41: Physicochemical

Sehaspreet Kaur Toor1, Jai Prakash Kushwaha1, Vikas Kumar Sangal1

  • 1a Department of Chemical Engineering , Thapar Institute of Engineering and Technology , Patiala , Punjab , India.

Journal of Environmental Science and Health. Part A, Toxic/Hazardous Substances & Environmental Engineering
|January 11, 2019
PubMed

Keywords:
4-chloro-o-toluidineAdsorptionMCM-41aromatic aminesmesoporous silica nanoparticles

More Related Videos

Author Spotlight: Standardizing the Development of Amine-Based Silica Composites as CO2 Adsorbents for Direct Air Capture08:00

Author Spotlight: Standardizing the Development of Amine-Based Silica Composites as CO2 Adsorbents for Direct Air Capture

Published on: September 29, 2023

3.2K
Surface Properties of Synthesized Nanoporous Carbon and Silica Matrices09:31

Surface Properties of Synthesized Nanoporous Carbon and Silica Matrices

Published on: March 27, 2019

10.0K

Related Concept Videos

Basicity of Aromatic Amines01:18

Basicity of Aromatic Amines

The basicity of aromatic amines is much weaker than that of aliphatic amines due to the involvement of the lone pair of electrons over the N atom in resonance with the aryl rings. Generally, the electron-donating ability of any substituents on the aryl ring of aromatic amines increases the basicity of the amine by increasing electron density, and hence the availability of lone pair on the nitrogen. On the other hand, electron-withdrawing functional groups on the aryl ring of amines decrease the...
8.0K
Basicity of Heterocyclic Aromatic Amines01:25

Basicity of Heterocyclic Aromatic Amines

Heterocyclic amines, where the N atom is a part of an alicyclic system, are similar in basicity to alkylamines. Interestingly, the heterocyclic amine having a nitrogen atom as part of an aromatic ring has much less basicity than its corresponding alicyclic counterpart. For this reason, as presented in Figure 1, piperidine (pKb = 2.8) is significantly more basic than pyridine (pKb = 8.8).
7.0K
Dynamic Equilibrium02:20

Dynamic Equilibrium

A reversible chemical reaction represents a chemical process that proceeds in both forward (left to right) and reverse (right to left) directions. When the rates of the forward and reverse reactions are equal, the concentrations of the reactant and product species remain constant over time and the system is at equilibrium. A special double arrow is used to emphasize the reversible nature of the reaction. The relative concentrations of reactants and products in equilibrium systems vary greatly;...
62.6K
Free Energy and Equilibrium02:56

Free Energy and Equilibrium

The free energy change for a process may be viewed as a measure of its driving force. A negative value for ΔG represents a driving force for the process in the forward direction, while a positive value represents a driving force for the process in the reverse direction. When ΔGrxn is zero, the forward and reverse driving forces are equal, and the process occurs in both directions at the same rate (the system is at equilibrium).
Recall that Q is the numerical value of the mass action...
27.2K
The Equilibrium Binding Constant and Binding Strength02:18

The Equilibrium Binding Constant and Binding Strength

The equilibrium binding constant (Kb) quantifies the strength of a protein-ligand interaction. Kb can be calculated as follows when the reaction is at equilibrium:
15.0K
Calculating the Equilibrium Constant02:46

Calculating the Equilibrium Constant

The equilibrium constant for a reaction is calculated from the equilibrium concentrations (or pressures) of its reactants and products. If these concentrations are known, the calculation simply involves their substitution into the Kc expression.
For example, gaseous nitrogen dioxide forms dinitrogen tetroxide according to this equation:
38.0K