Antagonistic paralogs control a switch between growth and pathogen resistance in C. elegans

Kirthi C Reddy1, Tal Dror1, Ryan S Underwood1

  • 1Division of Biological Sciences, University of California, San Diego, La Jolla, CA United States of America.

Plos Pathogens
|January 15, 2019
PubMed

Related Concept Videos

Methods for Controlling Microbial Growth01:29

Methods for Controlling Microbial Growth

Microbial growth control refers to various methods employed to inhibit, reduce, or eliminate microorganisms to ensure safety and hygiene across different settings. These methods are categorized based on the target environment and the level of microbial control required.Biocides are versatile agents designed to control microorganisms by either inhibiting their growth or outright killing them. These agents work through various physical, chemical, mechanical, or biological mechanisms. The...
1.7K
Switching of BJT01:22

Switching of BJT

Switching behavior in Bipolar Junction Transistors (BJTs) is a fundamental aspect utilized in various electronic circuits, particularly for digital logic applications like switches and amplifiers. In a typical switching circuit, a BJT alternates between cut-off and saturation modes, corresponding to the "off" and "on" states, respectively, thus behaving like an ideal switch.
Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are...
857
Physical Methods for Controlling Microbial Growth: Temperature01:23

Physical Methods for Controlling Microbial Growth: Temperature

Heat is a widely used method to control microbial growth by targeting and denaturing cellular proteins, thereby killing or inactivating microbes. This method's effectiveness is quantified using parameters such as the thermal death point (TDP), thermal death time (TDT), and decimal reduction time (D value). TDP represents the lowest temperature at which all microorganisms in a liquid suspension are eliminated within 10 minutes, whereas TDT is the time necessary to achieve sterilization at a...
1.1K
Physical Methods for Controlling Microbial Growth: Radiation and Filtration01:26

Physical Methods for Controlling Microbial Growth: Radiation and Filtration

Radiation and filtration are essential tools for microbial control, targeting microorganisms through distinct mechanisms. Radiation eliminates microbes by damaging their DNA, either killing them or inhibiting their growth. Based on wavelength, radiation is classified into two types: nonionizing and ionizing radiation.Non-ionizing radiation, such as UV radiation (200–400 nm), is absorbed by DNA, causing defects that effectively disinfect surfaces, air, and water, including safety cabinets.
1.1K
Cholinergic Antagonists: Pharmacokinetics01:24

Cholinergic Antagonists: Pharmacokinetics

Cholinergic antagonists—such as antimuscarinics—are available in oral, topical, ocular, parenteral, and inhalational formulations. Most antimuscarinics are oral formulations,  while scopolamine is available as a topical patch, and ipratropium and tiotropium are available as inhalation aerosols or powders. Atropine, tropicamide, and cyclopentolate are topically instilled in the eye. Most antimuscarinics are lipid-soluble and readily absorbed from the gastrointestinal tract and...
950
Resistivity01:22

Resistivity

When a voltage is applied to a conductor, an electrical field is generated, and charges in the conductor feel the force due to the electrical field. The current density that results depends on the electrical field and the properties of the material. In some materials, including metals at a given temperature, the current density is approximately proportional to the electrical field. In these cases, the current density can be modeled as:
4.5K