Injectable autologous chondrocyte implantation (ACI) in acetabular cartilage defects-three-year results

David R Krueger1, Markus Gesslein2, Michael Schuetz1

  • 1Center for Musculoskeletal Surgery, Charité-Universitätsmedizin Berlin, Charitéplatz 1, Berlin, Germany.

Related Concept Videos

Lumber Defects01:23

Lumber Defects

Lumber defects, which can affect both the appearance and structural integrity of wood, include a variety of growth and manufacturing flaws. Growth defects such as knots and knotholes occur where branches were once attached to the tree trunk, with knotholes forming when these knots fall out. Other natural defects include decay and insect damage, which compromise the wood's strength and durability.
Shakes are minor fractures that run along or across the wood's annual rings, while wane is...
516
Growth of Cartilage and Bone Tissue01:27

Growth of Cartilage and Bone Tissue

Chondrocytes form a temporary cartilaginous model by dividing and secreting a thick gel-like extracellular matrix. Once the chondrocytes undergo programmed cell death, osteoblasts enter the site of the cartilaginous model. The process of replacing the temporary cartilaginous model with bone in an ordered manner is called endochondral ossification. In endochondral ossification, not all of the cartilage is replaced by bone tissue. Some cartilage that performs a protective and supportive function...
4.2K
Gas Chromatography: Sample Injection Systems01:08

Gas Chromatography: Sample Injection Systems

In gas chromatography, the sample is introduced as a vapor plug into the carrier gas stream for high efficiency and resolution. A microsyringe injects the sample solution into a heated sample port, vaporizing it and mixing it with the carrier gas. This process is important to ensure the sample is properly prepared for analysis. Thermally sensitive samples can be injected directly into the column and volatilized by slowly increasing the column temperature.
Two primary injection methods are used...
1.6K
Nonlinear Pharmacokinetics: Drug Elimination for IV Bolus Injection00:59

Nonlinear Pharmacokinetics: Drug Elimination for IV Bolus Injection

In pharmacokinetics, the elimination rate of a drug following a capacity-limited model is primarily controlled by two parameters: Vmax and KM. These parameters are crucial in how the drug behaves inside the body after administration.
Following the administration of a single intravenous (IV) bolus injection, we can determine the concentration of the drug in the plasma at any given time. This calculation is achieved using a specific equation that integrates the values of Vmax and KM.
We can also...
412
Drug Accumulation During Multiple Dosing: Repetitive IV Injections01:21

Drug Accumulation During Multiple Dosing: Repetitive IV Injections

Calculating drug dosage and accumulation in multiple-dose regimens is crucial for achieving therapeutic efficacy while avoiding toxicity. This involves determining the plasma drug concentrations over time to optimize dosing schedules. The principle of superposition is fundamental in this process, allowing for the prediction of drug concentration in plasma following multiple doses based on single-dose data.The principle of superposition asserts that the plasma concentration-time curves from...
279
Reproductive Cloning01:27

Reproductive Cloning

Reproductive cloning is the process of producing a genetically identical copy—a clone—of an entire organism. While clones can be produced by splitting an early embryo—similar to what happens naturally with identical twins—cloning of adult animals is usually done by a process called somatic cell nuclear transfer (SCNT).
Somatic Cell Nuclear Transfer
In SCNT, an egg cell is taken from an animal and its nucleus is removed, creating an enucleated egg. Then a somatic...
32.7K