Related Experiment Video
Updated: Jan 30, 2026

2-Methacryloyloxyethyl Phosphorylcholine Polymer Treatment of Complete Dentures to Inhibit Denture Plaque Deposition
Published on: December 26, 2016
Novel anti-biofouling bioactive calcium silicate-based cement containing 2-methacryloyloxyethyl phosphorylcholine
Jae-Sung Kwon1, Myung-Jin Lee1, Ji-Young Kim2
1Department and Research Institute of Dental Biomaterials and Bioengineering, Yonsei University College of Dentistry, Seoul, Republic of Korea.
Abstract:
Calcium silicate-based cements (CSCs) are commonly used for endodontic procedures; however, their antibacterial effects are limited. The objective of this study was to develop a 2-methacryloyloxyethyl phosphorylcholine (MPC)-incorporated CSC with improved antibacterial properties, while maintaining the original advantageous features of CSC. MPC was incorporated into a commercial CSC (Endocem MTA) at 0 wt% (control), 1.5%, 3.0 wt%, 5.0 wt%, 7.5 wt%, and 10 wt%. The setting time, compressive strength, water sorption, and glycerol contact angle were measured. Protein absorption was measured and bacterial adhesion on the surface was evaluated using Enterococcus faecalis. The bactericidal effect was examined by the disc diffusion test. Mineralization ability was assessed based on calcium ion deposition, as assessed by alizarin red staining, after immersion into Hank's balanced salt solution for 7 days. High concentrations of MPC in CSC (7.5 wt% and 10 wt%) increased the setting time, reduced compressive strength, and reduced wettability. MPC (3 wt%) had greater protein repellent and anti-biofouling effects than those of control and test materials (P < 0.001). However, no bactericidal effect was observed for any control or test materials. There was greater calcium ion deposition on the surface of MPC-supplemented CSC than on the control (P < 0.001). The addition of 3 wt% MPC polymer to CSC confers protein-repellent properties and reduced bacterial attachment, with the potential for improved mineralization.
Related Concept Videos
Hydration of Cement
Soundness of Cement
Portland Cement
Fineness of Cement
Direct...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...

