Related Experiment Video
Updated: Jan 30, 2026

Lower-Limb Biomechanical Characteristics Associated with Unplanned Gait Termination Under Different Walking Speeds
Published on: August 25, 2020
Lower limb joint angle variability and dimensionality are different in stairmill climbing and treadmill walking
P C Raffalt1,2, S Vallabhajosula3, J J Renz4
1Julius Wolff Institute for Biomechanics and Musculoskeletal Regeneration, Charité - Universitätsmedizin Berlin, Berlin, Germany.
Abstract:
The present study tested if the quadratic relationship which exists between stepping frequency and gait dynamics in walking can be generalized to stairmill climbing. To accomplish this, we investigated the joint angle dynamics and variability during continuous stairmill climbing at stepping frequencies both above and below the preferred stepping frequency (PSF). Nine subjects performed stairmill climbing at 80, 90, 100, 110 and 120% PSF and treadmill walking at preferred walking speed during which sagittal hip, knee and ankle angles were extracted. Joint angle dynamics were quantified by the largest Lyapunov exponent (LyE) and correlation dimension (CoD). Joint angle variability was estimated by the mean ensemble standard deviation (meanSD). MeanSD and CoD for all joints were significantly higher during stairmill climbing but there were no task differences in LyE. Changes in stepping frequency had only limited effect on joint angle variability and did not affect joint angle dynamics. Thus, we concluded that the quadratic relationship between stepping frequency and gait dynamics observed in walking is not present in stairmill climbing based on the investigated parameters.
Related Concept Videos
Development of the Limb Synovial Joints
The mesenchymal stem cells differentiate into chondrocytes that form the hyaline cartilage, and later the cartilaginous model of the bone. This model further transforms into a bone. This process is known as endochondral ossification.
During development, the limbs...
Actin Treadmilling
Structural Joints: Synovial Joints
Structural Joints: Fibrous Joints
Suture
All the bones of the skull, except for the mandible, are joined to each other by a fibrous joint called a suture. The fibrous connective tissue found at a suture strongly unites the adjacent skull bones and thus helps to protect the brain and form the face. In...
Structural Joints: Cartilaginous Joints
There are two types of cartilaginous joints:
Synchondrosis
A synchondrosis ("joined by cartilage") is a cartilaginous joint where bones are connected by hyaline cartilage. Synchondrosis may be temporary...
Joints
Structural joint classifications are based on the material that makes up the joint as well as whether or not the joint contains a space between the bones. Joints are structurally classified as fibrous, cartilaginous, or synovial.
Fibrous Joints Are Immovable
The bones of a...

