Related Experiment Video
Updated: Jan 30, 2026
Development of Sulfidogenic Sludge from Marine Sediments and Trichloroethylene Reduction in an Upflow Anaerobic Sludge Blanket Reactor
Published on: October 15, 2015
Levels of polybrominated diphenyl ethers and hexabromocyclododecane in treatment plant sludge: Implications on sludge
Hale Demirtepe1, Ipek Imamoglu1
1Department of Environmental Engineering, Middle East Technical University, Ankara, Turkey.
Abstract:
Past usage of polybrominated diphenyl ethers (PBDEs) and hexabromocyclododecane (HBCDD) in commercial products resulted in their continuous emission from sources. Wastewater treatment plants (WWTP) are the main sinks resulting from their industrial and domestic usage as well as atmospheric deposition. This preliminary study examined levels of PBDEs and HBCDD in urban and industrial WWTP sludge samples for the first time from Turkey. PBDE concentrations (sum of 26 congeners) of eight samples collected from four WWTPs were between 300 and 655 ng g-1 dw and 67-2.5*107 ng g-1 dw, and HBCDD concentrations (sum of α-, β-, and γ- diastereoisomers) ranged 75-616 ng g-1 dw and 13-416 ng g-1 dw, for urban and industrial WWTP samples, respectively. Although PBDEs have never been produced in Turkey, the highest PBDE concentration in sewage sludge worldwide was identified in one of the WWTPs. PBDE and HBCDD levels in other sludge samples were comparable to those reported in the literature. Application of a chemical mass balance model (CMB) suggested: (i) the main source of PBDEs as deca-BDE mixture; (ii) influence of a background air PBDE profile for one of the industrial WWTPs, having low contamination; (iii) indoor dust PBDE contamination as another source for urban WWTPs. The preliminary results for BFR levels in Turkey were discussed in terms of sludge disposal methods used worldwide, and the need for regulatory limits for BFRs in sludge management.
More Related Videos
Related Concept Videos
02:29Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
02:36Crown Ethers
02:28Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent...
02:17Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
01:56Plant Hormones
00:53Tonicity in Plants