Related Experiment Video
Updated: Jan 30, 2026

Murine Full-thickness Skin Transplantation
Published on: January 2, 2017
Is split-thickness skin graft safe for coverage of the vascular pedicle in free tissue transfer?
1a Department of Plastic Surgery, Asan Medical Center , University of Ulsan College of Medicine , Seoul , Republic of Korea.
Introduction:
If the pedicle is compressed after microanastomosis during free flap reconstruction, additional tissue such as skin graft or vascularized flap is needed to avoid tension. Performing a skin graft directly on the vessel might cause considerable problems. We aimed to analyze the safety of skin grafting on the anastomosis site of the free flap.
Patients And Methods:
A total of 15 patients who underwent skin grafting on the anastomosis site were analyzed. The skin graft take-up rate and flap-related complications were evaluated postoperatively.
Results:
All involved sites were the extremities (10 hands and 5 feet). An anterolateral thigh free flap in six patients and a toe pulp free flap in nine patients were harvested. The mean follow-up period was 10.4 ± 6.2 months. The graft area for the pedicle was 2.8 ± 1.6 cm2. The percentage of final graft take was 99.3 ± 1.2% at 30 days postoperatively without flap compromise.
Conclusion:
During free flap surgery in the upper or lower extremities, inadequate pedicle coverage may occur easily. Applying a split-thickness skin graft in such cases can be safe and one of the simple methods.
Related Concept Videos
Seedless Vascular Plants
Guidelines and Strategies for Safe Computer Charting
Maintain Confidentiality and Security:
¹H NMR: Complex Splitting
Splitting diagrams or splitting tree diagrams are routinely used to depict such complex couplings. While drawing splitting diagrams, the splitting with the larger coupling constant is usually applied...
Plant Cells and Tissues
¹H NMR Signal Multiplicity: Splitting Patterns
Design Example: Deciding Thickness of Lubricating Fluid in a Shaft
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular velocity...

