Regional Anesthetic Blocks in Plastic Surgery Using Portable Ultrasound: A Simplified Approach

Christopher Homsy1, John T Lindsey

  • 1From the Division of Plastic and Reconstructive Surgery, Tulane University, New Orleans, LA.

Annals of Plastic Surgery
|January 30, 2019
PubMed
Abstract

Related Concept Videos

Local Anesthetics: Clinical Application as Intravenous Regional Anesthesia01:16

Local Anesthetics: Clinical Application as Intravenous Regional Anesthesia

Intravenous regional anesthesia or the Bier block technique is used to anesthetize a specific limb or extremity. It uses exsanguinated or blood-drained vessels to transport local anesthetics or LAs to the peripheral nerve trunks. Lidocaine without vasoconstrictors like epinephrine is most commonly used for this technique. Other drugs used are prilocaine, ropivacaine, and chloroprocaine. Bupivacaine is not recommended for this technique due to its high cardiac toxicity.
One of the advantages of...
1.3K
Local Anesthetics: Clinical Application as Surface, Infiltration, and Conduction Block Anesthesia01:30

Local Anesthetics: Clinical Application as Surface, Infiltration, and Conduction Block Anesthesia

Depending on the target organ, local anesthetics (LAs) can be administered via various routes. In surface anesthesia, LAs are applied directly to the surface of the skin or mucous membranes. It is widely used for topical skin numbing before venipuncture or minor surgical procedures. Commonly used surface local anesthetics are lidocaine or benzocaine sprays or creams. Surface anesthesia occurs within 5 minutes and lasts for about 60 minutes. One of the main disadvantages of topical anesthesia is...
2.0K
Plasticity00:58

Plasticity

Plasticity is the property where an object loses its elasticity and undergoes irreversible deformation, even after the deformation forces are eliminated. If a material deforms irreversibly without increasing stress or load, then this is called ideal plasticity. For example, when a force is applied to an aluminum rod, it changes its shape, but it does not return to its original shape once the force is removed. Plastic deformation or ductility is thus a permanent deformation or change in the...
3.1K
Plasticizers01:31

Plasticizers

Water-reducers, or plasticizers, are chemical admixtures used in concrete to improve strength and workability. These additives reduce the water-cement ratio without compromising workability, lower the cement content while maintaining the same workability, or increase workability to assist concrete placement in inaccessible areas.
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
366
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
569
Plastic Deformations01:14

Plastic Deformations

It is essential to understand how structural members behave under plastic deformation when the bending stress exceeds the material's yield strength. This state of deformation permanently alters the shape of the member, in contrast to the linear elastic behavior observed before yielding. The strain at any point in the member is expressed in terms of maximum strain. Notably, the neutral axis, which coincides with the centroid during elastic bending, shifts away from the centroid under plastic...
431