Related Experiment Video
Updated: Jan 29, 2026

Formulation and Characterization of Bioactive Agent Containing Nanodisks
Published on: March 17, 2023
Bioactive exopolysaccharide from Neopestalotiopsis sp. strain SKE15: Production, characterization and optimization
Tayebeh Fooladi1, Mohammad Reza Soudi1, Nayyereh Alimadadi1
1Department of Microbiology, Faculty of Biological Sciences, Alzahra University, 1993893973, Tehran, Iran.
Abstract:
Fungal exopolysaccharides are powerful resources of medicinal applications. Neopestalotiopsis sp. SKE15 was isolated and identified according to phenotypical and genotypical analyses (GenBank Accession No. MG649986). The exopolysaccharide (EPS) was produced by cultivation of mycelia in broth culture and extracted. The production was optimized to 2.02 g/l after selection of agitation, temperature, FeSO4 and K2HPO4 concentrations as the most influencing factors using Placket-Burman design and then by applying response surface methodology. Analytical Tools showed that the EPS is composed of a polysaccharide (1.5-2.1 × 106 Da) and its probable low molecular weight derivatives, in a wide range of chain lengths, among them an oligosaccharide of about 1970 Da was dominant. GC-MS (Gas chromatography-mass spectrometry) analysis revealed the EPS was mainly constructed from d-glucose, sorbitol and D-galactose. The EPS showed antibacterial activity against Staphylococcus aureus ATCC 25923, Bacillus subtilis ATCC 6633 and Pseudomonas aeruginosa ATCC 27853. DPPH (1,1-diphenyl-2-picryl-hydrazyl) and hydroxyl radical scavenging activity assays showed strong antioxidant activity of the EPS. A challenge with three different cancerous cell lines showed cytotoxic activity of the EPS at final concentration of 100 and 200 μg/ml. Further investigation on medicinal applications of the biopolymer is promising.
More Related Videos
Related Concept Videos
Optimal Foraging
Thermal Strain
Shearing Strain
Measurements of Strain
Optimization Problems
Strain Energy
Consider a rod that is fixed at one end and subjected to an axial force at the free end. This axial force induces stress within the rod, leading to its elongation. As the axial force increases, so does the elongation of the rod, illustrating a direct relationship between the force applied and the resulting...

