Related Experiment Video

Updated: Jan 29, 2026

Clean Sampling and Analysis of River and Estuarine Waters for Trace Metal Studies
10:44

Clean Sampling and Analysis of River and Estuarine Waters for Trace Metal Studies

Published on: July 1, 2016

12.1K

Water Environmental Capacity Calculated Based on Point and Non-Point Source Pollution Emission Intensity under Water

Lina Chen1,2,3, Longxi Han4,5, Junyi Tan6

  • 1Key Laboratory of Integrated Regulation and Resource Development on Shallow Lake of Ministry of Education, College of Environment, Hohai University, Nanjing 210098, China. chenlina2001@163.com.

International Journal of Environmental Research and Public Health
|February 6, 2019
PubMed

Keywords:
control sectionpoint and non-point sourcetidal river network areauncertaintywater environmental capacitywater quality assurance rate

More Related Videos

Studying Neurobehavioral Effects of Environmental Pollutants on Zebrafish Larvae07:06

Studying Neurobehavioral Effects of Environmental Pollutants on Zebrafish Larvae

Published on: February 5, 2020

6.6K
Extraction and Detection of Geosmin and 2-Methylisoborneol in Water and Fish using High-Capacity Sorptive Extraction Probes and GC-MS11:59

Extraction and Detection of Geosmin and 2-Methylisoborneol in Water and Fish using High-Capacity Sorptive Extraction Probes and GC-MS

Published on: July 3, 2025

1.5K

Related Concept Videos

Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
557
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
388
Quality Assurance01:19

Quality Assurance

Quality assurance is the overarching term used to describe the activities employed to ensure the proper performance of a system. These activities can be classified into three categories: quality control, quality assessment, and internal corrective measures. Typically, these activities work cyclically: quality control is performed before and during the analysis, while quality assessment occurs during and after the investigation. Internal corrective measures are implemented based on the findings...
2.0K
Water: A Bronsted-Lowry Acid and Base02:30

Water: A Bronsted-Lowry Acid and Base

The reaction between a Brønsted-Lowry acid and water is called acid ionization. For example, when hydrogen fluoride dissolves in water and ionizes, protons are transferred from hydrogen fluoride molecules to water molecules, yielding hydronium ions and fluoride ions:
58.5K
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
56.8K
The Water Cycle01:00

The Water Cycle

The Earth’s hydrosphere includes all of the areas where the storage and movement of water occurs. Since water is the basis of all living processes, the cycling of water is extremely important to ecosystem dynamics.
28.5K