Related Experiment Video
Updated: Jan 29, 2026

An Easy and Flexible Inoculation Method for Accurately Assessing Powdery Mildew-Infection Phenotypes of Arabidopsis and Other Plants
Published on: March 9, 2021
Association of Spring Pruning Practices with Severity of Powdery Mildew and Downy Mildew on Hop
David H Gent1, Mark E Nelson2, Gary G Grove2
1United States Department of Agriculture-Agricultural Research Service (USDA-ARS), Forage Seed and Cereal Research Unit, and Department of Botany and Plant Pathology, Oregon State University, Corvallis 97331.
Abstract:
Downy mildew (caused by Pseudoperonospora humuli) and powdery mildew (caused by Podosphaera macularis) are important diseases of hop in the Pacific Northwest United States, and cultural practices may affect the severity of both diseases. The association of spring pruning quality and timing with severity of downy mildew and powdery mildew was assessed through analysis of survey data collected from commercial hop yards in Oregon and Washington. Among 149 hop yards surveyed, the most common pruning method was chemical desiccation (48% of yards), mechanical pruning (23%), or a combination of these practices (15%). The quality of pruning was assessed using a three-category ordinal scale ("excellent", "moderate", or "poor") based on the amount of foliage remaining on plants following pruning. Excellent pruning quality was attained more often in yards pruned twice (74.6 to 82.1% of yards) versus once (33.8% of yards), independent of pruning method. Seasonal severity of downy mildew in Oregon increased approximately twofold with reduction in pruning quality from excellent to moderate to poor. Pruning quality was not significantly related to levels of powdery mildew on leaves or cones in Oregon. Under more severe disease pressure in Washington, however, seasonal severity of powdery mildew on leaves and the incidence of cones with powdery mildew were significantly greater in yards that had poor pruning compared with excellent pruning. Moreover, yards that had excellent pruning quality received, on average, 1.1 to 1.5 fewer fungicide applications per season for downy mildew or powdery mildew compared with yards that had moderate or poor pruning quality. This savings was associated with delayed initiation of the first application by 7.5 to 14.2 days in yards with excellent pruning quality. Replicated experiments in commercial yards in Oregon quantified the effect of delaying pruning timing 5 to 21 days compared with growers' standard practices on the diseases and yield. Downy mildew suppression by delayed pruning was dependent on cultivar and year of sampling, being significantly reduced fivefold only in 'Willamette' in 2007. Severity of powdery mildew and cone yield was similar between plots that received the delayed or standard pruning timing treatments. Collectively, these studies emphasize that early spring sanitation measures are associated with reduced primary inoculum and are critically important for managing both downy mildew and powdery mildew. A savings of at least one fungicide application per year appears achievable when spring pruning is conducted thoroughly and slightly delayed compared with growers' current practices.
Related Concept Videos
Frequency of Spring-Mass System
Consider a block on a spring on a frictionless surface. There...
Association Areas of the Cortex
Prefrontal Association Area: This area is located in the frontal lobe and is involved in planning, decision-making, and moderating social behavior. It connects with primary motor areas,...
Associative Learning
Classical conditioning, also known...
Characteristics of Practical Op Amps
The ratio of differential gain to the common-mode gain is defined as the common-mode rejection ratio (CMRR). This ratio quantifies the ability of operational amplifiers (op-amps) to reject common-mode...
Theoretical Foundations of Nursing Practice
Theories provide a perspective to assess patients' conditions and organize data and methods. They also assist in analyzing and interpreting information. They represent a...
Equivalent Circuits for Practical Transformers
In a practical transformer, each winding exhibits resistance and leakage reactance. The...

