A low-damage plasma surface modification method of stacked graphene bilayers for configurable wettability and...

In this work, we study surface functionalization effects of artificially stacked graphene bilayers (ASGBs) to control its wetting properties via low-damage plasma. The ASGBs were prepared on a SiO₂/Si substrate by stacking two monolayer graphene, which was grown by chemical vapor deposition. As a result, the low-damage plasma functionalization of ASGBs could hold both the key characteristics of surface functionalization and electrical transport properties of graphene sheets. To characterize ASGBs, Raman and x-ray photoelectron spectroscopy (XPS) were used to determine the degree of defect formation and functionalization. Meanwhile, the degree of the wettability of the ASGBs surface was determined by optical contact angle (CA) measurements. Based on experimental results, the compositional ratio of C-OH + COOH was found to increase 67% based on the analysis of XPS spectra after low-damage plasma treatment. This treatment effect can also be found with 75.3% decrease in the CA of water droplet on graphene. In addition, we found that the ratio of 2D/(D + G') in Raman spectra shows strong correlation to the measured CA; it can be a reliable indicator of ASGBs surface wettability modification. This work showed that we obtained a higher degree functionalization of ASGBs without degrading the under-layer structure of ASGBs due to the moderate low-damage plasma treatment. The presented process technique of controllable wettability through low-damage plasma treatment can be employed for potential application in graphene-based sensors/devices.