Combustion and emission characteristics for a marine low-speed diesel engine with high-pressure SCR system

In order to avoid the production of sulfates and nitrates in marine diesel engines that burn sulfur-containing fuels, the operating temperature of their high-pressure selective catalytic reduction (HP-SCR) systems should be higher than 320 °C. For marine low-speed diesel engines, only the pre-turbine exhaust gas temperature can meet this requirement under specific conditions, with the main engine modulation method helping to increase the exhaust gas temperature. However, the main engine modulation method brings down the power output and fuel economy of the main engine and causes the matching problem of the turbine and the other devices with the main engine. The original engine model of the marine low-speed diesel engine and the high-pressure SCR system configuration model have been constructed using one-dimensional simulation software. In addition, the performance of the high-pressure SCR system under the conditions of low-sulfur and high-sulfur exhaust gas was thoroughly analyzed. Moreover, the two main engine modulation schemes of the scavenging bypass and the turbine exhaust bypass of the original engine matching with the high-pressure SCR system were studied. The study found that the weighted average value of the NOx under the condition of low-sulfur exhaust gas met with the requirement of the IMO Tier III regulations when the low-speed diesel engine was matched with the high-pressure SCR system. However, the weighted average value of the NOx under the condition of high-sulfur exhaust gas was slightly higher than that required by the IMO Tier III regulation. In addition, the optimal main engine modulation scheme for this low-speed diesel engine was clarified by comparing the effects of the scavenging bypass and the turbine exhaust bypass modulation on the exhaust performance, and the working performance of the original engine. With an opening of 0.4 of the CBV valve under 25% engine load, the weighted average NOx of the original exhaust gas was 3.38 g/(kW·h), the power had decreased by 0.7%, and the fuel consumption had increased by 1.0%. Furthermore, when the EGB valve opening was 0.3, the weighted average value of NOx was 3.31 g/(kW·h), the power had reduced by 2.4% and the fuel consumption had increased by 2.5%. Both modulation scheme methods made the exhaust performance of the original engine meet the requirements of the IMO Tier III emission regulations, but the scavenging bypass modulation scheme had less impact on the original engine's performance.