A field assessment of bauxite residue rehabilitation strategies
Elisa Di Carlo1, Amiel Boullemant2, Ronan Courtney1
1University of Limerick, Department of Biological Sciences & The Bernal Institute, Co. Limerick, Ireland.
Abstract:
Bauxite residue, the by-product of the alumina industry, is mainly stored in land-based bauxite residue disposal areas (BRDAs). Environmental concern has been raised due to the large volumes in stockpile, the high alkalinity of the material, as well as the presence of elevated concentrations of trace elements. If not adequately managed, BRDAs can act as a source of pollution. In order to minimize the environmental risk, revegetation is implemented to stabilize the residue against water and wind erosion. Currently, two main approaches are used: the use of amendments or the installation of a capping layer. However, few studies evaluating the long-term success and self-sustainability of the rehabilitation programs have been published. A series of field-established rehabilitation strategies reflecting both direct revegetation and revegetation on capping layer were assessed in terms of both soil and plant quality. Soil physico-chemical properties, including pseudo-total and plant-available fractions of nutrients and trace elements, were determined over a summer and winter seasons and aerial portions of vegetation were analysed for nutrients and trace elements. Failure to adequately lower alkalinity remains the major constraint to long-term rehabilitation success of bauxite residue. This is evidenced from poor soil properties in unamended residue and in residue capped with a shallow soil layer, as well from vegetation displaying excessive concentrations of certain elements. Certain elements exceeded typical ranges for non-contaminated soils (i.e. Cr, Fe, Na, Ni and V), with some showing excessive plant-available fractions (i.e. of Al, As, Cr, Hg and V). Vegetation analysis found excessive uptake of some elements (i.e. of Al, Na, Fe, Cr and V). Future attempts for bauxite residue rehabilitation should include both gypsum and organic amendments, while a capping layer may only be effective if either a deep layer (>1 m) is installed or if the underlying residue is sufficiently treated prior to capping.
Related Concept Videos
Residual Plots
When the residual values are plotted against the variable x, it is called a residual...
Residual Stresses
Strategies for Assessing and Addressing Confounding
Confounding can be addressed at both the design phase of a study and through analytical methods after data...
Residual Stresses in Circular Shafts
Residual Stresses in Bending
Residuals and Least-Squares Property
If the observed data point lies above the line, the residual is positive, and the line underestimates the actual data value for y. If the observed data point lies below the line, the residual is negative, and the line overestimates the actual data value for y.
The process of fitting the best-fit...


