Related Experiment Video
Updated: Jan 29, 2026

A Standardized Pipeline for Examining Human Cerebellar Grey Matter Morphometry using Structural Magnetic Resonance Imaging
Published on: February 4, 2022
Automated quantitative morphometry of vertebral heights on spinal radiographs: comparison of a clinical workflow tool
Klaus Engelke1,2,3, B Stampa4, P Steiger5
1Institute of Medical Physics, University of Erlangen, Erlangen, Germany. klaus.engelke@bioclinica.com.
Abstract:
A workflow tool for measurements of vertebral heights on lateral spine radiographs based on automated placements of 6 points per vertebra was evaluated. The tool helps to standardize point placement among operators. Its success rate is very good in normal vertebrae but lower in vertebrae with more severe fractures. Manual corrections were required in 192 of 1257 analyzed vertebrae.
Introduction:
To evaluate a new workflow tool (SA) for the automated measurements of vertebral heights on lateral spine radiographs.
Methodology:
Lateral radiographs from 200 postmenopausal women were evaluated at two visits. Genant's semi-quantitative fracture assessment (SQ) and manual quantitative morphometry (QM) results were available from prior analyses. Vertebral heights from point placements using SA were compared with manual 6-point placement QM. Differences were quantified as RMS coefficient of variations (rmsCV) and standard deviations (rmsSD).
Results And Conclusions:
SA required manual corrections in 192 of 1257 vertebrae. SA heights were larger than QM ones by 2.2-3.6%. Correlations (r2 > 0.92) between SA and QM were very high. Differences between QM and SA were higher for fractured (SQ = 2; rmsCV% 14.5%) than for unfractured vertebrae (rmsCV% 4.2-4.7%). rmsCV% for QM varied between 3 and 6% and for SA between 2.5 and 7.5%. For SA, highest rmsCV% was obtained for T4 and L4. Manual correction mostly affected the end vertebrae T4 and L4. SA helps to standardize point placement among operators. The algorithm success rate is very good in normal vertebrae but lower in vertebrae with more severe fractures, which are of greater clinical interest but are more readily recognized without morphometric measurements.
More Related Videos
Related Concept Videos
Local Anesthetics: Clinical Application as Spinal Anesthesia
Measurement: Standard Units
Muscles of the Vertebral Column
Superficial Layer:
The superficial layer consists primarily of the splenius muscles, which include the splenius capitis and splenius cervicis. These muscles are mainly responsible for the head and cervical spine movements, including extension, rotation, and lateral bending. The splenius capitis...
Articulations of the Vertebral Column
The Sense of Self: Reflected Self-Appraisal and Social Comparison
Vertebral Column: Regions and Curvature
Regions of the Vertebral Column
In an adult, the spine is subdivided into five regions: the cervical, the thoracic, the lumbar, the sacral, and the coccygeal region. The spine initially develops as a series of 33 vertebrae; after 20 years of age, the nine bones in the sacral region, five sacral, and four coccygeal bones fuse to form...

