Aggregation, segregation, and dispersal of homotypic germ plasm RNPs in the early zebrafish embryo

Celeste Eno1, Christina L Hansen1, Francisco Pelegri1

  • 1Laboratory of Genetics, University of Wisconsin - Madison, Madison, Wisconsin.

Abstract

Related Concept Videos

Law of Segregation01:49

Law of Segregation

When crossing pea plants, Mendel noticed that one of the parental traits would sometimes disappear in the first generation of offspring, called the F1 generation, and could reappear in the next generation (F2). He concluded that one of the traits must be dominant over the other, thereby causing masking of one trait in the F1 generation. When he crossed the F1 plants, he found that 75% of the offspring in the F2 generation had the dominant phenotype, while 25% had the recessive phenotype.
77.9K
Distribution and Dispersion00:54

Distribution and Dispersion

To understand intra-specific interactions in populations, scientists measure the spatial arrangement of species individuals. This geographic arrangement is known as the species distribution or dispersion. Highly territorial species exhibit a uniform distribution pattern, in which individuals are spaced at relatively equal distances from one another. Species that are highly tied to particular resources, such as food or shelter, tend to concentrate around those resources, and thus exhibit a...
25.1K
Segregation in Fresh Concrete01:16

Segregation in Fresh Concrete

Segregation in fresh concrete is a phenomenon where the components of the concrete mix separate, leading to uneven distribution and compromised structural integrity. This separation typically occurs when concrete is subjected to excessive horizontal movement within forms, or when it is dropped from considerable heights or forced through narrow, winding paths. As a result, heavier coarse aggregate particles settle at the bottom, while lighter, finer materials such as cement and water rise to the...
576
Aggregates Classification01:29

Aggregates Classification

Aggregate classification is generally based on its size, petrographic characteristics, weight, and source. Size classification ranges from coarse to fine aggregates, defined by the size of the particles. Coarse aggregates are particles that do not pass through ASTM sieve No. 4, and aggregates that pass through the sieve are fine aggregates.
Petrographic classification groups aggregates based on common mineralogical characteristics. Some of the common mineral groups found in aggregates are...
1.0K
Bonding and Strength of Aggregate01:12

Bonding and Strength of Aggregate

The bond between aggregate particles and the cement matrix is significantly influenced by the shape and surface texture of the aggregates. High-strength concretes benefit from a rougher texture, which leads to stronger bonding due to greater adhesion. Angular aggregates with larger surface areas also enhance this bond. The bonding quality, however, is complex to assess as no universally accepted test exists. Good bonding is indicated when a crushed concrete specimen shows some aggregate...
493
Specific Gravity of Aggregate01:19

Specific Gravity of Aggregate

Aggregates typically contain pores, which can be either permeable or impermeable. Considering the pores in the aggregates, the specific gravity of aggregates is defined in three different forms, namely, bulk or gross specific gravity, apparent specific gravity, and absolute specific gravity.
Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...
812