Sandwiching h-BN Monolayer Films between Sulfonated Poly(ether ether ketone) and Nafion for Proton Exchange Membranes
Jiaman Liu1, Liwei Yu2, Xingke Cai1
1Shenzhen Environmental Science and New Energy Technology Engineering Laboratory, Shenzhen Geim Graphene Center (SGC), Tsinghua-Berkeley Shenzhen Institute (TBSI) , Tsinghua University , Shenzhen 518055 , China.
Abstract:
Two-dimensional (2D) hexagonal boron nitride (h-BN) has attracted great interest due to its excellent chemical and thermal stability, electrical insulating property, high proton conductivity, and good flexibility. Integration of 2D h-BN into commercial proton exchange membranes (PEMs) has the potential to improve ion selectivity while maintaining the proton conductivity of PEMs simultaneously, which has been a longstanding challenge in membrane separation technology. Until now, such attempts are only limited in mechanically exfoliated small area h-BN and in proof-of-concept devices, due to the difficulty of growing and transferring large area uniform h-BN monolayers. Here, we develop a space-confined chemical vapor deposition approach and achieve the growth of wafer-scale uniform h-BN monolayer films on Cu rolls. We further develop a Nafion functional layer assisted transfer method which effectively transfers as-grown h-BN monolayer films from the Cu roll to sulfonated poly(ether ether ketone) (SPEEK) membrane. The as-fabricated Nafion/h-BN/SPEEK sandwich structure is used as the membrane and compared with the pure SPEEK membrane for flow batteries. Results show that the sandwich membrane exhibits ion selectivity 3-fold greater than that of a pure SPEEK membrane ( i.e., 32.1 × 104 vs 9.7 × 104 S min cm-3). In addition, we fabricate vanadium flow batteries using the Nafion/h-BN/SPEEK sandwich membrane and find that the sandwich structure does not affect the proton transport but inhibits vanadium crossover at low current density (<120 mA cm-2) due to the selective blocking of vanadium ions by 2D h-BN. As a result, the sandwich membrane exhibits a significantly improved Coulombic efficiency and energy efficiency, ∼95% and ∼91%, respectively. Our results suggest that a functional layer/2D film/target substrate-based sandwich structure shows clear potential for future 2D material-based membranes in separation technologies.
More Related Videos
Related Concept Videos
02:29Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
02:36Crown Ethers
02:28Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent...
02:17Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
02:23Autoxidation of Ethers to Peroxides and Hydroperoxides
02:18Ethers to Alkyl Halides: Acidic Cleavage