The Influence of Tillage on Dispersal of Tilletia indica Teliospores from a Concentrated Point Source

T W Allen1, F Workneh1, K C Steddom2

  • 1Texas Agricultural Experiment Station, Bushland 79012-0010.

Plant Disease
|February 17, 2019
PubMed

Keywords:
Karnal bunt

Related Concept Videos

Concentration Cells02:41

Concentration Cells

A concentration cell is a type of a  voltaic cell constructed by connecting two almost identical half-cells, both based on the same half-reaction and using the same electrode, differing only in the concentration of one redox species. A concentration cell's potential, therefore, is determined only by the concentration difference of the particular redox species.
Consider the following voltaic cell:
25.8K
Distribution and Dispersion00:54

Distribution and Dispersion

To understand intra-specific interactions in populations, scientists measure the spatial arrangement of species individuals. This geographic arrangement is known as the species distribution or dispersion. Highly territorial species exhibit a uniform distribution pattern, in which individuals are spaced at relatively equal distances from one another. Species that are highly tied to particular resources, such as food or shelter, tend to concentrate around those resources, and thus exhibit a...
25.1K
Solution Concentration and Dilution02:59

Solution Concentration and Dilution

The relative amount of a given solution component is known as its concentration. Often, though not always, a solution contains one component with a concentration that is significantly greater than that of all other components. This component is called the solvent and may be viewed as the medium in which the other components are dispersed or dissolved. Solutions in which water is the solvent are, of course, very common on our planet. A solution in which water is the solvent is called an aqueous...
131.8K
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
630
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
693
Concentration and Rate Law03:03

Concentration and Rate Law

The rate of a reaction is affected by the concentrations of reactants. Rate laws (differential rate laws) or rate equations are mathematical expressions describing the relationship between the rate of a chemical reaction and the concentration of its reactants.
For example, in a generic reaction aA + bB ⟶ products, where a and b are stoichiometric coefficients, the rate law can be written as:
38.2K